After 50 years the connections between fresh water pipes (800-1000mm diameter) need to be repaired due to aging and dissolution of the filling material. Only in Vienna 3000km of pipes need to be improved, which requires a robotic solution. The main challenge is to accurate place the robot in the center of the pipe while overcoming the push back forces and vibrations caused in the cleaning proce...

This paper experimentally studies the heat absorption performance of a heat sink with vertical embedded heat pipes in the aluminum blade. The cooling system with embedded heat pipes distributes heat from the CPU to both the base plate and the heat pipes, and then transfer heat from fins to the Environment. The thermal resistance and heat transfer coefficient are evaluated for natural convection...

Structural health monitoring of cracked structures is one of beloved subject of researchers recently. Consider of crack behavior in the water and energy pipeline is important because of environmental problems. In this paper consider of crack parameters in the underwater pipe subjected to mechanical transient load is investigated. For this purpose, three- dimensional parametric model of cracked ...

in the construction process of a plastic concrete cut-off wall, concreting is usually performed using the termie pipe method. in this method, concreting is performed from the lowest point in the excavated trench (containing the slurry) using a funnel and the pipe connected to it. the concrete poured in the funnel gradually settles in the panel through the termie pipe which is beneath the slurry...

SuperCritical Water Oxidation (SCWO) process is investigated at the Institut of Technical Chemistry, ITC-CPV. The objectives were to determine destruction efficiencies of model compounds and industrial waste effluents and to study the feasability of the SCWO process. Two continuous SCWO bench scale plants are operated: a pipe reactor and a transpiring wall reactor system (design data: T = 630 °...

In this study, in order to increase the heat transfer rate in concentric double-pipe heat exchangers by an active method, a rotating ball valve was mounted downstream of the outer pipe end and used as a pulse generator. In the experimental set-up, hot water (40-70 °C) was passed through the inner pipe with fixed mass flow rate (Reynolds number ≈ 10,200) while cold water was passed through the a...

Green buildings are increasingly being plumbed with crosslinked polyethylene (PEX) potable water pipe. Tap water quality was investigated at a six month old plumbing system and chemical and odor quality impacts of six PEX pipe brands were examined. Eleven PEX related contaminants were found in the plumbing system; one regulated (toluene) and several unregulated: Antioxidant degradation products...

The study of two-phase fluid flow behavior in hydraulic structures such as pressurized flow tunnels, culverts, sewer pipes, junctions and other similar conduits is of great importance. A two-phase mixture flowing in a pipe can exhibit several interfacial geometries such as bubbles, slugs or films, depending on the fluid and hydrodynamic properties of flow. The main variables, giving rise to a v...

Drag reduction (DR) for air and water flowing in an inclined 0.0127 m diameter pipe was investigated experimentally. The fluids had an annular configuration and the pipe is inclined upward. The injection of drag reducing polymer (DRP) solution produced drag reductions as high as 71% with concentration of 100 ppm in the pipeline. A maximum drag reduction that is accompanied (in most cases) by a ...

An extensive product range is mandatory to be a key player in the pipe insulation market. The polyurethane preinsulated pipe producers are responding to global opportunities by diversifying their activities into industrial, marine, oil and gas applications. Moreover, the requirements for traditional district heating preinsulated pipes including initial thermal conductivity and its ageing perfor...