We present results on the leveling of polymer microdroplets on thin films prepared from the same material. In particular, we explore the crossover from a droplet spreading on an infinitesimally thin film (Tanner's law regime) to that of a droplet leveling on a film thicker than the droplet itself. In both regimes, the droplet's excess surface area decreases towards the equilibrium configuration...

Accurate steady and unsteady numerical solutions of the full 2-D governing equations – that model the forced film condensation flow of saturated vapor over a semi-infinite horizontal plate (the problem of Cess [1] and Koh [2]) are obtained over a range of flow parameters. The results presented here are used to better understand the limitations of the well-known similarity solutions given by Koh...

A new measurement technique for the determination of the heat transfer coefficient and the film cooling effectiveness is presented. It is based on a regression of multiple transient liquid crystals experiments using an electrical heater-foil producing a nonhomogeneous surface heat flux. This is particularly interesting for film-cooled surfaces where each cooling hole in the heater-foil leads to...

The flow of a liquid film over a rapidly rotating horizontal disk has numerous industrial applications including pharmaceuticals, chemical engineering, bioengineering, etc. The analysis and control of complex fluid flows over a rapidly rotating horizontal disk is an important issue in the experimental fluid mechanics. The spinning disk reactor exploits the benefits of centrifugal force, which p...

the increase of cell temperature with increased irradiance is probably the mostsignificant disadvantage of using photovoltaic modules equipped with booster reflectors. the aimof this study is to investigate the possibility of improving the performance of a photovoltaic waterpumping system by using a booster reflector and to keep the temperature of pv panels at a lowlevel by cooling pv panels wi...

The gas flow estimation is crucial for the proper operation and monitoring of turbocharged (TC) engines with a torque structured engine control unit (ECU). This paper presents mean value models developed for modeling gas flow over the compressor, the turbine and the wastegate (WG) in a TC gasoline engine not equipped with a hot film air-mass flow meter (HFM). The turbine flow ...

The aim of this work was to study the effect of several process parameters used during pellets coating in two wurster fluid beds of different scales on: a) the uniformity of pellets coating, and b) the presence of an initial burst in the release profile caused by the existence of a significant fraction of pellets having a very thin film coating. The pellets used in this work presented high insu...