O. Chivu, Engineering and Tehnological Systems Management Faculty, Polytehnic University of Bucharest, Romania The metallic structures realized from OL 52.4k have a very wide use, but they are used especially in case of tools used in mining plants. Due to the important constraints these welded structures are submitted into practice, it is very important to determine a set of optimal parameters ...

An advanced computerized complex for Ultrasonic Peening (UP) of parts and welded elements based on piezoelectric transducers was developed recently. The complex consists of a compact ultrasonic transducer, generator and a laptop with an Expert System for UP optimum application: maximum possible increase in fatigue life of parts and welded elements with minimum cost, labor and power consumption....

V. Lazić, D. Arsić, S. Aleksandrović, A. Ilić, L. Ivanović, M. Djordjević, Faculty of Engineering, University of Kragujevac, Kragujevac, Serbia A. Sedmak, Faculty of Mechanical Engineering, University of Belgrade, Belgrade, Serbia This paper presents the analysis of the influence of temperature on mechanic properties of the base material and welded joints made of high strength steel. The joints...

Evaluation of welding process such as metal inert gas welding and tungsten inert gas arc welding on tensile, bend and hardness properties of austenitic stainless steel SS347H(18Cr 10Ni 1Cb ), T22(21⁄4Cr Mo) and T91(9Cr 1Mo V) grades are studied. Tubes of 54 mm of outer diameter and 4 mm of wall thickness is used as a base material in the following combination SS347H VS T91 and T91 VS T22 is wel...

It is well known that the mechanical properties of materials depend of the rolling direction, which means that the direction of specimen cutting affect the obtained values. This feature also exists in the welded joint, where the anisotropy is caused by direction of the deposit welded layers. One high-carbon steel is surface welded by flux-cored wire and specimens were cut in order to determine ...

Welded joints are prone to fatigue cracking with the existence of welding defects and bending stress. Fracture mechanics is a useful approach in which the fatigue life of the welded joint can be predicted. The key challenge of such predictions using fracture mechanics is how to accurately calculate the stress intensity factor (SIF). An empirical formula for calculating the SIF of welded joints ...

Simplified fatigue and fracture mechanics based assessment methods are widely used by the industry to determine the structural integrity significance of postulated cracks, manufacturing flaws, service-induced cracking or suspected degradation of engineering components under normal and abnormal service loads. In many cases, welded joints are the regions most likely to contain original fabricatio...

A time-dependent fatigue reliability assessment approach is proposed for welded details of orthotropic steel decks (OSDs) using long-term strain monitoring data. The fatigue reliability limit function of the welded details is established based on the Eurocode specifications. Depending on the distribution characteristics of the measured daily equivalent stress range, either the lognormal distrib...

Distribution of residual stresses arising after welding is quite complex and inhomogeneous. Many factors have influence on the magnitude and the profile of the stress distribution curve. In the present paper an x-ray technique was used to analyze the residual stress distribution in steel sheets jointed by industrial welding with linear or circular weld seams. Interpretation of experimental resu...

In this work, silver nanowire inks with hydroxypropyl methylcellulose (HPMC) binders were coated on polyethylene terephthalate (PET) substrates and welded via flash white light and ultraviolet C (UV-C) irradiation to produce highly conductive transparent electrodes. The coated silver nanowire films were firmly welded and embedded into PET substrate successfully at room temperature and under amb...