Strain distribution of Al 1100 was numerically investigated during cyclic expansion extrusion (CEE) process using finite element method (FEM). Die angle, corner fillet radius and die chamber diameter were considered as die parameters and friction factor and number of passes as process parameters. The effects of these parameters were investigated on the effective strain and strain homogeneity in...

In this paper, overall heat transfer coefficient and friction factor of water based γ-Al2O3 nanofluid in a double tube counter flow heat exchanger have been measured experimentally under turbulent flow condition. For better dispersion of γ-Al2O3 nanoparticles in distilled water, magnetic stirrer and ultrasonic vibrator (with a power of 240 kW and frequency of 35 kHz) were implemented. The stabi...

A review of studies focused on promoting the rate heat transfer with help an optimum rise in friction factor, by offering a simulated irregularity to interior surface absorber plate SAH, is expressed. In this article effort has been made explore different coarseness configurations as used number researchers boost SAH rate. Furthermore, correlations developed for Nusselt and factor are also pres...

A shallow-layer model for granular flows is completed with a closure relation for the macroscopic bed friction or basal roughness obtained from micro-scale discrete particle simulations of steady flows. We systematically vary the bed friction by changing the contact friction coefficient between basal and flowing particles, while the base remains geometrically rough. By simulating steady uniform...

Water-hammer is a transient condition which may occur in a network as a result of rapid or slow valve closures, pump failures, changes in turbine loading, etc. It creates high and low pressure waves which travel along the system and decay as a result of wall shear stress. Comparison o experimental and theoretical results revealed the failure of steady or quasi-steady models in correctly predict...

In the study, the thermal-hydraulic performance of the zigzag channels with circular cross-section was analyzed by Computational Fluid Dynamics (CFD). The standard K-Ꜫ turbulent scalable wall functions were used for modeling. The wall temperature was assumed constant 353 K and water was used as the working fluid. The zigzag serpentine channels with bend angles of 5 - 45° were studied for turbul...

Recent research on friction in robot joints and transmission systems has considered meshing friction a position-dependent friction component. However, in this paper we show experimental evidence that meshing friction depends highly on joint speed. We identify the meshing friction in the gearboxes of a robotic leg, and we propose a new mathematical model that considers the rate dependency of mes...

Although Darcy-Weisbach (D-W) equation has been accepted as a standard resistance equation in pressurized flow, some researchers and engineers still prefer to utilize Hazen-Williams (H-W) equation for analyzing water distribution networks (WDNs) in practice. The main difference between roughness coefficients of these two resistance equations is that D-W friction factor varies with Reynolds numb...

The objective of the present study was to evaluate if anterior load carriage would increase the likelihood of slips or falls while walking over a slippery floor surface. The study hypothesized that anterior load carriage may alter spatial-temporal characteristics, such as heel contact velocity, walking velocity (i.e., the whole body center-of-mass velocity), and step length, as well as friction...

The characteristics of fully-developed, laminar, pressure-driven, incompressible flow in rough circular microchannels are studied. A novel analytical model is developed that predicts the increase in pressure drop due to wall roughness in microtubes. The wall roughness is assumed to posses a Gaussian isotropic distribution. The present model is compared with experimental data, collected by other...