Study Design Retrospective review. Objective The purpose of this study was to determine the radiographic impact of a transforaminal lumbar interbody fusion (TLIF) versus a cantilever TLIF technique on segmental lordosis, segmental coronal alignment, and disk height. Methods A retrospective review was done of all patients undergoing TLIF procedures from 2006 to 2011 by three spine surgeons. Trad...

We explore analytically, numerically, and experimentally the spectral properties of the flexural vibrations of micron scale cantilevers in a viscous fluid that are driven externally or by Brownian motion. Although the physical origins of driven and thermal cantilever dynamics are quite different, we show that in each case the dynamics can be calculated deterministically using an impulse or step...

The aim of this paper is firstly to address the consequences of the nonlinear interactions between higher order modes and the first order mode of a flexible cantilever beam. The tested cantilever beam exhibited numerous nonlinear phenomena that are commonly observed in many flexible structures. The experimental results have shown that active control of the nonlinear vibration in a flexible stru...

We demonstrate photothermally excited force modulation microscopy (PTE FMM) for mechanical property characterization across a broad frequency range with an atomic force microscope (AFM). Photothermal excitation allows for an AFM cantilever driving force that varies smoothly as a function of drive frequency, thus avoiding the problem of spurious resonant vibrations that hinder piezoelectric exci...

In the present work microstructural evolution of A356 Aluminum alloy using an inclined cooling plate casting process for thixoforming feedstock production is investigated. The resultant microstructure was evaluated and compared with those of the same alloy produced by the conventional casting process, i.e. directly cast in the same mold without using an inclined cooling plate. It was found that...

This study proposes a new microcantilever design with a rectangular hole at the fixed end of the cantilever that is more sensitive than conventional ones. A commercial finite element analysis software ANSYS is used to analyze it. The Stoney equation is first used to calculate the surface stress induced moment, and then applied to the microcantilever free end to produce deflection. The stress an...

An analytical expression relating mass and position of a particle attached on a cantilever to the resulting change in cantilever resonant frequency is derived. Theoretically, the position and mass of the attached particle can be deduced by combining measured resonant frequencies of several bending modes. This finding is verified experimentally using a microscale cantilever with and without an a...

A composite self-excited PZT-glass cantilever (4mm in length and 2mm width) was fabricated and used to measure attachment of model protein and a model pathogen. Key feature of the microcantilever is that its resonant frequency is dependent on its mass. The cantilever had a mass sensitivity of 5x10-11 g/Hz. The change in resonant frequency was measured as antibody, protein, reacts with the amine...

The static pull-in instability of beam-type micro-electromechanical systems is theoretically investigated. Two engineering cases including cantilever and double cantilever micro-beam are considered. Considering the mid-plane stretching as the source of the nonlinearity in the beam behavior, a nonlinear size-dependent Euler-Bernoulli beam model is used based on a modified couple stress theory, c...

Micromolar levels of urea [1–20 mM] on surface micromachined polysilicon cantilever beams immobilized with the enzyme urease was studied. Urea hydrolyses to ammonia and carbon dioxide which are volatile in nature. Monitoring the change in resonance frequency of a urease immobilized cantilever beam during the course of urea hydrolysis, mediated by the immobilized enzyme can give us information o...