The effect of chemical treatment at fiber–plastic interface and fiber loading level on creep property of bamboo fiber high-density polyethylene (BF/HDPE) composites was investigated. For single modifier systems, the use of maleic anhydride grafted polyethylene (PE-g-MA) as a coupling agent helped reduce the creep and achieved the optimum effect at the 5.7% loading level. The addition of either ...

When an anisotropic material is subject to creep conditions and a complex state of stress, an anisotropic creep damage behavior is observed. Previous research has focused on the anisotropic creep damage behavior of isotropic materials but few constitutive models have been developed for anisotropic creeping solids. This paper describes the development of a new anisotropic tertiary creep damage c...

[1] The characterization of time-dependent brittle creep, promoted by chemically active pore fluids, is fundamental to our understanding of the long-term evolution and dynamics of the Earth’s crust. Here we report results from a study of the influence of temperature on both short-term strength and time-dependent brittle creep in three sandstones under triaxial stress conditions. We show that an...

The creep aging behaviors of retrogressed Al-Zn-Mg-Cu alloy were studied by uniaxial tensile creep tests at 140 ◦C. The effects of creep aging time and applied stress on microstructures and properties of the studied alloy were investigated by using transmission electron microscope (TEM), hardness, and corrosion resistance tests. Results show that the effects of the creep aging process on micros...

It has been suggested that the endurance of cemented femoral reconstructions in total hip arthroplasty is affected by the creep of acrylic cement, but it is not known to what extent cement creeps under loading conditions in vivo, or how this affects load transfer. We have simulated the long-term creep properties of acrylic cement in finite-element models of femoral stem constructs and analysed ...

S U M M A R Y We present a model of localized, aseismic fault creep during the full interseismic period, including both transient and steady fault creep, in response to a sequence of imposed coseismic slip events and tectonic loading. We consider the behaviour of models with linear viscous, non-linear viscous, rate-dependent friction, and rateand state-dependent friction fault rheologies. Both ...

Concrete, the solid that forms at room temperature from mixing Portland cement with water, sand, and aggregates, suffers from time-dependent deformation under load. This creep occurs at a rate that deteriorates the durability and truncates the lifespan of concrete structures. However, despite decades of research, the origin of concrete creep remains unknown. Here, we measure the in situ creep b...

Cyclic plasticity and creep are the primary design considerations of 1 and 2 stage gas turbine blades. Directionally-solidified (DS) Ni-base materials have been developed to provide (1) greater creep ductility and (2) lower minimum creep rate in solidification direction compared to other directions. Tracking the evolution of deformation in DS structures necessitates a constitutive model having ...

In the pressure vessel and piping and power industries, creep deformation has continued to be an important design consideration. Directionally solidified components have become commonplace. Creep deformation and damage is a common source of component failure. A considerable effort has gone into the study and development of constitutive models to account for such behavior. Creep deformation can ...

The effects of microstructures during creep on the ultrasonic attenuation have been investigated for Ni based superalloy (IN738LC). The cuboidal γ′ precipitates in the virgin material became coarsened preferentially in the direction perpendicular to the applied stress axis as creep time increased. The length of γ′ precipitates increased with creep time, while the width increased slightly. The i...