Effect of multipath amplification is found in ultrawideband wireless communication systems with chaotic carrier, whereas information is transmitted with chaotic radio pulses. This effect is observed in multipath environment (residence, office, industrial or other indoor space). It is exhibited as an increase of signal power at the receiver input with respect to the case of free space. Multipath...

Jiyoun Lim et al. 377 A novel power amplifier for a polar transmitter is proposed to achieve better spectral performance for a wideband envelope signal. In the proposed scheme, 2-bit sigma-delta (ΣΔ) modulation of the envelope signal is introduced, and the power amplifier configuration is modified in a binary form to accommodate the 2-bit digitized envelope signals. The 2-bit ΣΔ modulator lower...

High sampling rate analog-to-digital converters (ADCs) are commonly used to sample complex modulated signals at intermediate frequencies in modern wireless receiver designs. Often CMOS switched-capacitor based ADCs are selected for such designs due to their attractive low cost and power dissipation. These ADCs utilize an unbuffered front end directly coupled to the sampling network, which prese...

144606-7171-IJET-IJENS © December 2014 IJENS I J E N S Abstract— This paper shows the design of a broadband low noise amplifier (LNA) for ultra-wideband (UWB) applications. The proposed LNA uses cascode configuration technique followed by an inductive inter-stage network to realize the flat gain throughout the UWB band. The inductive inter-stage network is cascaded to a common source amplifier ...

The design issues in designing low noise amplifier (LNA) for Software-Defined-Radio (SDR) are reviewed. An inductor-less wideband low noise amplifier aiming at low frequency band (0.2-2 GHz) for Software-DefinedRadio is presented. Shunt-shunt LNA with active feedback is used as the first stage which is carefully optimized for low noise and wide band applications. A digitally controlled second s...

Insulator-based dielectrophoresis enables contact-less separation and analysis of biosystems, but it is unable to operate effectively in the MHz frequency range, which is necessary for the manipulation of biological cells based on the characteristic electrophysiology of their cytoplasm or biomolecular preconcentration based on their unique conformation. To address the steep drop in output power...

Highly linear CMOS radio receivers increasingly exploit linear RF V-I conversion and passive down-mixing, followed by an OpAmp based Transimpedance Amplifier at baseband. Due to the finite OpAmp gain in wideband receivers operating with large signals, virtual ground is imperfect, inducing distortion currents. We propose to apply a negative conductance to cancel this distortion. In an RF receive...

A wideband 2-1-1 cascaded ΣΔ modulator with a single-bit quantizer in the two first stages and a 4-bit quantizer in the final stage is developed. To reduce sensitivity of digital-to-analog converter (DAC) nonlinearities in the feedback of the last stage, dynamic element matching (DEM) is introduced. This paper presents two modelling approaches: The first is MATLAB description and the second is ...

In this paper, a robust cyclic ADC architecture with βencoder is proposed and circuit scheme using switched-capacitor (SC) circuit is introduced. Different from the conventional binary ADC, the redundancy of proposed cyclic ADC outputs β-expansion code and has an advantage of error correction. This feature makes ADC robust against the offset of comparator capacitor mismatch and finite DC gain o...