II-VI semiconductors form an important class of opto-electronic materials. CdSe is a promising material for the fabrication of photovoltaic devices. Polycrystalline CdSe films have been deposited onto ultra clean glass substrates by sintering process. The optical band gap of these films was determined by reflectance measurements in wavelength range 400-850 nm. The band gap of these films was ob...

The residual porosity is an unavoidable phenomenon of the components produced by powder metallurgy process which in turn largely affects the strength property of the same. Now a day it is possible to control porosity of powder metallurgy components and retain them to desired amount when required. The porosity of a powder metallurgy component is greatly depends on the sintering temperature. In t...

The influence of surface hydroxylation on nucleation and sintering of gold nanoparticles was studied by comparison of Au deposition and thermal sintering on ideally terminated MgO(001) and hydroxylated MgO thin films, respectively. A combination of different spectroscopic techniques (TDS, XPS, IRAS) allows to establish a correlation between the degree of surface hydroxylation and the stability ...

Multiwall carbon nanotube (MWNT) reinforced silicon nitride ceramics matrix composites have been prepared. The hot isostatic press (HIP)-sintering method was used for composite processing. Bending strength and elastic modulus of MWNT-silicon nitride composites showed a considerable improvement compared to matrices with added carbon fiber, carbon black or graphite. However, the silicon nitride s...

The current research compares the processing influence of Spark plasma sintering (SPS) over conventional sintering on aluminium alloy AA2219 MWCNT composites. Also investigations on the effect of MWCNT content on the properties of composite are presented and discussed. Though unreinforced matrix processed under SPS showed 24.68% improvement in hardness over conventional, the same could not be r...

The effective shear and bulk viscosity, as well as dynamic viscosity, describe the rheological properties of the ceramic body during the liquid phase sintering process. The rheological parameters depend on the physical and thermo-mechanical characteristics of the material such as relative density, temperature, grain size, diffusion coefficient, and activation energy. Thermal behavior of the cer...

Physical, electrical, and morphological properties of thermally annealed silver nanoparticle thin films are described. These solutiondeposited nanoparticle thin films form highly conducting films at low curing temperatures via sintering due to the high surface area to volume ratio. Measured resistivity correlates with thickness decrease and densification, and can be explained by a simple geomet...

Metallic nanoparticle inks are used for printed electronics, but to reach acceptable conductivity the structures need to be sintered, usually using a furnace. Recently, sintering by direct resistive heating has been demonstrated. For a microscopic understanding of this Joule heating sintering method, we studied the entire process in real time inside a transmission electron microscope equipped w...

To gain a better understanding and control of the Selective Laser Sintering (SLS) process, more fundamental and modeling work is needed. A simple analytical ray-tracing model has been developed to simulate the energy absorption and penetration in SLS. The model is applied to FeCu and WC-Co powder mixtures, irradiated by Nd-YAG or CO2 laser. It gives an evaluation of the total energy incoupling ...

Polycrystalline samples of Lead free (K0.5Na0.5)1−x(Li)x(Sb)x(Nb)1−xO3 ceramics with nominal compositions (x = 0.040 to 0.060) have been prepared by high temperature solid state reaction technique. X-ray diffraction (XRD) pattern shows that the crystal structure transforms from orthorhombic to tetragonal as Li and Sb content increases. Normal sintering process yield compounds with density ~98.2...