A novel cobalt-free Cu1.2Mn1.8O4 spinel coating is prepared and evaluated for the metal interconnect of solid oxide fuel cell. Mn-35Cu and Co-35Mn alloy coatings are deposited on 430 SS substrate and then in-situ oxidized in air at 750 ◦C for 100 h. XRD results confirm that Cu1.2Mn1.8O4 spinel with some Mn2O3 is formed, and the average thickness of the coating is 70–80 μm according to cross sec...

epoxy powder coatings containing zinc aluminum phosphate (zap) and zinc phosphate (zp), which are the 2nd and 1st generation of phosphate-based pigments respectively, were applied to the surface of mild steel sheets. the anticorrosive performances of the coated samples were studied using electrochemical impedance spectroscopy (eis). cathodic disbonding resistance and the adhesion performance of...

BACKGROUND Immobilizing bioactive molecules and osteoconductive apatite on titanium implants have investigated direct ossification. In this study, hydroxycholesterol (HC) was immobilized with apatite on titanium through simply adsorption or sandwich-like coating. Three kinds of hydroxycholesterol were chosen to induce ossification: 20α-hydroxycholesterol (20α- HC), 22(S)-hydroxycholesterol (22(...

Lithium iron borate (LiFeBO3) is a promising cathode material due to its high theoretical specific capacity, inexpensive components and small volume change during operation. Yet, challenges related to severe air- and moisture-induced degradation have prompted the utilization of a protective coating on the electrode which also improves the electronic conductivity. However, not much is known abou...

low water-wettability and oxidation resistance of graphite have limited its application in carbon containing refractory castables. the aims of this study were improvement of water-wettability and the oxidation resistance of natural flaky graphite by applying an oxide coating on its surface. to develop the coating, magnesium aluminate spinel sol was formulated via a citrate-nitrate route and gra...

objective: osseous defects around dental implants are often seen when implants are placed in areas with inadequate alveolar bone, or around failing implants. bone regeneration in these areas using bone grafts or its substitutes may improve dental implants prognosis. the aim of this study was to prepare and characterize the bioactive glass nanopowder and development of its coating for treatment ...

Calcium silicate (CS) ceramic is a good coating candidate for biomedical implants to improve biocompatibility and accelerate early osseointegration. However, the poor fracture toughness and wear resistance of this ceramic material restricts the long-term performance of implants. In this study, graphene plates (GPs) were used as reinforcement to improve the mechanical properties of CS coating. C...

Biocompatibility of biomedical devices can be improved by endothelialization of blood-contacting parts mimicking the vascular endothelium's function. Improved endothelialization might be obtained by using biomimetic coatings that allow local sustained release of biologically active molecules, e.g. anti-thrombotic and growth-inducing agents, from nanoliposomes. We aimed to test whether incorpora...

We analyze the Brownian thermal noise of a multilayer dielectric coating used in high-precision optical measurements, including interferometric gravitational-wave detectors. We assume the coating material to be isotropic, and therefore study thermal noises arising from shear and bulk losses of the coating materials. We show that coating noise arises not only from layer thickness fluctuations, b...

A study has been carried out to determine the effect of coating two commercial glass-ionomer cements in either petroleum jelly or wax. After coating, specimens were stored in water for 24 or 168 hours, then the coating removed and the surface examined. Coating in wax was found to increase the surface hardness significantly compared with the uncoated control, whereas coating the specimens in pet...