The paper gives an outline of the non-destructive evaluation (NDE) methods currently being pursued at the Admiralty Marine Technology Establishment, Dunfermline, Scotland. The methods are being used to locate and characterise fatigue cracks in high yield strength welded steel structures. The techniques have been applied principally to large fatigue models (5' and 9' diameter) as part of a compr...

Empirical and numerical microscopic features of moving traffic jams are presented. Based on a single vehicle data analysis, it is found that within wide moving jams, i.e., between the upstream and downstream jam fronts there is a complex microscopic spatiotemporal structure. This jam structure consists of alternations of regions in which traffic flow is interrupted and flow states of low speeds...

Shrink-fitting, a common bonding technique in metal assemblies, was used for mortise and tenon wood joints. The joints had considerable strength. Shrink-fitting yielded joint strengths comparable to those obtained by using several welded dowels. Increasing the number of welded dowels, however, produced joints of higher strength than those bonded just by shrink-fitting. Combining in the same joi...

The friction welding of Zr55Al10Ni5Cu30 bulk metallic glasses (BMG) has been tried. An apparatus for the friction welding of BMGs adopting a pneumatic cylinder and gripper based on a conventional lathe, and a welding process which provides a sufficient cooling rate after welding were devised. Friction time and friction pressure were chosen as the control parameters in the friction welding proce...

The reliability of welded structure can be evaluated through welding residual stress analysis and fatigue strength assessment. In this study, welding residual stresses of multi-pass dissimilar material welded joint between alloy 617 and 12Cr steel were analyzed numerically and experimentally. Fatigue strength was then assessed in the air. Based on results of welding residual stress analysis and...

There are many industries where austenitic stainless steel needs to be welded specially in power generation industries. Unfortunately the austenitic stainless welding has several fabrication and metallurgical drawbacks when welded by using conventional fusion welding methods, which can often leads to in-service failure. The most pronounced fabrication faults are hot cracks due to inadvertent us...

The aim of this study is to evaluate the microstructures, tensile lap shear strength, and fatigue resistance of 6022-T43 aluminum alloy joints welded via a solid-state welding technique-ultrasonic spot welding (USW)-at different energy levels. An ultra-fine necklace-like equiaxed grain structure is observed along the weld line due to the occurrence of dynamic crystallization, with smaller grain...

To improve the usage of material in fatigue loaded complex welded structures a better calculation method (based on FEA) is needed than what is available on the market and an improved management of weld quality. Improved FE-procedures are directly applicable to design of generic structural components within virtually all industries using CAD and FEtools, irrespective of industrial sector. More a...

Metallic tracheal stents have been used in the treatment of paediatric tracheomalacia for more than a decade. We describe a case in which critical airway obstruction occurred during removal of a welded tracheal stent using a rigid bronchoscope under general anaesthesia. Life-saving cardiopulmonary bypass was instituted urgently, and the welded stent was then removed successfully by directly ope...