We study drop impact on a deep pool of the same fluid, with an emphasis on the air layer trapped under the droplets from its formation to its rupture. The penetration velocity of the air layer at a very short time scale prior to its rupture is shown, using an energy argument and experimental verification, to be one-half of the impact velocity. We then deduce the dependence of the rupture positi...

Water-enhanced degradation of p-type low temperature polycrystalline silicon thin film transistors under negative bias temperature (NBT) condition is studied. H2O penetration into gate oxide network and the role of H2O during NBT stress are confirmed and clarified respectively. To prevent H2O diffusion, a combination of a layer of PECVD SiO2 and a layer of PECVD Si3N4 as passivation layers are ...

Measurements of the polar Kerr effect using a zero-area-loop Sagnac magnetometer on Pb/Ni and Al/(Co-Pd) proximity-effect bilayers show unambiguous evidence for the "inverse proximity effect," in which the ferromagnet induces a finite magnetization in the superconducting layer. To avoid probing the magnetic effects in the ferromagnet, the superconducting layer was prepared much thicker than the...

In a model consisting of a non-aqueous layer (representing the protoplasm) placed between an inner, more acid, aqueous layer (representing the sap) and an outer, more alkaline, aqueous solution (representing the external solution bathing a living cell) the penetration of potassium creates an outwardly directed potential against which potassium continues to diffuse inward, thereby increasing the...

OBJECTIVES The aim of this study was to compare the push-out bond strength and dentinal tubule penetration of root canal sealers used with coated core materials and conventional gutta-percha. MATERIALS AND METHODS A total of 72 single-rooted human mandibular incisors were instrumented with NiTi rotary files with irrigation of 2.5% NaOCl. The smear layer was removed with 17% ethylenediaminetet...

Two mid-infrared light sources, a broadband source from a Fourier Transform Infrared Spectrometer (FTIR) and a pulsed Quantum Cascade (QC) Laser, are used to measure angle-resolved backscattering in vivo from human skin across a broad spectral range. Scattering profiles measured using the FTIR suggest limited penetration of the light into the skin, with most of the light interacting with the st...

An edge-emitting laser diode is described in which the epitaxial upper cladding layer is replaced with a metal contact selected for its optical as well as electrical properties. The structure is demonstrated with an In0.1Ga0.9N multiple-quantum-well laser diode operating at 412 nm with silver rather than the typical p-type AlGaN for the upper cladding. Silver is effective as a cladding layer be...

Hybrid-layer degradation occurs because of acidic properties of currently used adhesive systems. Titanium tetrafluoride couples with tooth surface, and titanium compounds are not substituted. Caffeic acid phenethyl esther inhibits endogenous matrix metalloproteinases that cause hybrid-layer degradation. It was hypothesized that titanium tetrafluoride and caffeic acid phenethyl esther applicatio...

A typical mammalian egg is surrounded by an outer layer of about 3,000 cumulus cells embedded in an extracellular matrix rich in hyaluronic acid. A current, widely proposed model is that the fertilizing sperm, while it is acrosome intact, passes through the cumulus cell layer and binds to the egg zona pellucida. This current model lacks a well-supported explanation for how sperm penetrate the c...

Ocean upwelling rates are difficult to measure because of the relatively small velocities involved, and therefore are typically inferred from indirect methods such as heat budget estimates or tracer observations. Here we present the first results using a novel technique, based on the isotope Be, to infer rates of upwelling along the equator. Beryllium-7 (half-life1⁄453.3 d) is a cosmic-ray prod...