This paper investigates the effects of thin plastically deformable layers embedded in an elastic coating upon debonding of a multilayer from its substrate. Such coatings are normally deposited at high temperature and cooled to ambient, resulting in significant stresses from thermal expansion mismatch. Other stresses can develop during subsequent thermal cycling if volumetric changes such as pha...

The purpose of this study was to develop a new method of releasing fluorine in a controlled manner for applications in the field of orthodontic Ti-based wire, namely the coating of fluorides on Ti. Thin films of two fluoride compounds, CaF(2) and MgF(2), were coated on Ti via the electron-beam evaporation method. The fluorine was released rapidly from the as-deposited MgF(2) coating within a sh...

This article describes fretting behavior of zirconia and silicon nitride balls on an electro-deposited coating. Fretting tests are performed using a ball-on-flat configuration. The evolution of the kinetic friction coefficient is determined, along with slip ratio. Experimental results show that the steady-state friction coefficient between ceramic balls (Si₃N₄ and ZrO₂) and an electro-deposited...

A method has been developed to fabricate patterned arrays of micrometer-sized monodisperse solid particles of ammonium nitrate on hydrophobic silicon surfaces using inkjet printing. The method relies on dispensing one or more microdrops of a concentrated aqueous ammonium nitrate solution from a drop-on-demand (DOD) inkjet printer at specific locations on a silicon substrate rendered hydrophobic...

Direct chemical sensing in liquid environments using polymer-guided shear horizontal surface acoustic wave sensor platforms on 36 degrees rotated Y-cut LiTaO3 is investigated. Design considerations for optimizing these devices for liquid-phase detection are systematically explored. Two different sensor geometries are experimentally and theoretically analyzed. Dual delay line devices are used wi...

Human exposures to volatile organic compounds (VOCs) are associated with a wide range of health problems. Due to these adverse effects of VOCs on the human health, determination of trace levels of VOCs is very important for accurate assessment of indoor and outdoor exposure. Solid phase microextraction (SPME), needle trap device (NTD) and hollow fiber- liquid phase microextraction (HF-LPME) are...

The degradation of SiO, coatings deposited on alloys by metal organic chemical vapour deposition (MOCVD) in sulphidizing high-temperature environments is determined by delamination and crack formation. With increasing water concentration during deposition, the crack density in silica decreases and the critical thickness for delamination of SiO, coatings increases. This improvement is supposed t...

Selective Separation Sintering (SSS) is a powder layer based Additive Manufacturing approach. SSS can fabricate high temperature ceramic and metallic parts at comparatively lower cost with high quality. In the printing process a dry powder of higher sintering temperature is deposited into the base material which makes up the part. The inserted powder defines the boundary of the part and separat...

Optical properties and structure of antireflective coatings (AR) deposited from hydrolysed TEOS sol have been characterized in detail. The influence of various parameters on the formation of colloidal silica antireflective coatings by the dip-coating technique has been investigated. For the characterization of colloidal silica films, the UV-visible spectroscopy, laser ellipsometry, and atomic f...