This project deals with a grid connected wind-PV hybrid distributed generation system employing permanent magnet synchronous generator(PMSG) driven by a variable speed wind turbine and PV array connected to a load and the grid. PMSG wind turbine connected to a dc-dc converter via three phase diode rectifier and PV array along with a dc-dc converter connected to the DC link which operates under ...

Soft switching has the potential of reducing switch stresses and of lowering the switching losses as compared to hard switching. For this reason, several soft-switching topologies have been presented in the literature. Each topology has some advantages. Their operation, however, requires additional active and/or passive elements. This introduces additional cost and complexity. To understand the...

Variable speed operation of a wind turbine generator improves its energy capturing capability. Up to the present, the machines employed have been induction machines, conventional synchronous machines or DC machines. The major drawback of these machines is that a complicated arrangement of slip rings or commutators with brushes, and a full-rating power converter are required. Reliability and cos...

It is very important, to optimize of clean electrical energy by employing of variable Speed pumped storage power plant (VSPSP). Variable speed machines are used extensively in wind power plants and pumped storage power plants. Therefore, the advantages of this technology are including: stability, reliability, fast dynamic responses, frequency control and high efficiency of power system. By usin...

For analysis of the flow field of torque converter’s start operating performance, the paper established a mathematical model and simulated the numerical value of YJ series hydrodynamic torque converter. In view of the partial impact fluid and cavitation phenomenon in processes such as multiple flow area coupling algorithms the sliding mesh method cannot achieve the flow parameters real-time tra...

This paper presents Maximum Power Point Tracking (MPPT) controller design of Doubly Fed Induction Generator (DFIG) using Genetic Algorithm (GA). Essential feature of proposed controller is that it is used to trace the maximum power when wind speed is lower than the rated wind speed. Doubly-Fed Induction Generator DFIG has stator terminals are connected directly to the grid. However, the rotor t...

In order to enhance torque density of five-phase permanent magnetic synchronous motor with third harmonic injection for electric vehicles (EVs) applications, optimum seeking method for injection ratio of third harmonic was proposed adopting theoretical derivation and finite element analysis method, under the constraint of same amplitude for current and air-gap flux. By five-dimension space vect...

Interaction of the third harmonic magnetic field with the third harmonic current in a five-phase synchronous reluctance motor (SynRM) can produce additional torque. However, it is still not clear about the SynRM power factor and its impact on the associated power converter because of the third harmonic components. Using time-stepping finite-element method, a mathematical model of the SynRM, whi...

Variable speed operation is essential for large wind turbines in order to optimize the energy capture under variable wind speed conditions. Variable speed wind turbines require a power electronic interface converter to permit connection with the grid. The power electronics can be either partially-rated or fully-rated [1]. A popular interface method for large wind turbines that is based on a par...

The grid codes now require doubly fed induction generator (DFIG) wind turbines having the “low voltage ride-through (LVRT)” capability. However, a traditional DFIG with a partially rated back-to-back converter has inherent difficulties to ride through the grid faults, especially for the unbalanced grid faults. Modifications to the traditional DFIG configuration for ride-through have become nece...