Fracture toughness (K1C) of medium carbon steel (0.5% C) has been determined by round notched tensile specimen. Two notch diameters (5.6mm and 4.2mm) and three notch angles (α) namely 45, 60 and 75 have been used to observe the effect of notch diameters and notch angle on fracture toughness of the steel. By heat treatment the microstructure of the steel is also varied and its effect on the frac...

Ceramic/metal interfaces were studied that fail by atomistic separation accompanied by plastic dissipation in the metal. The macroscopic toughness of the specific Ni alloy/Al2O3 interface considered is typically on the order of ten times the atomistic work of separation in mode I and even higher if combinations of mode I and mode II act on the interface. Inputs to the computational model of int...

Analysis has been performed on fracture initiation near a crack in a brittle material with strength described by Weibull statistics. This nonlocal fracture model allows for a direct correlation between near crack-tip stresses and failure. Predictions are made for both the toughness and average fracture initiation angle of a crack under mixed-mode loading. This is pertinent for composites and is...

sudden fracture is one of the major failure modes in brittle materials. plexiglass (polymethyl methacrylate) is a well known brittle polymer, widely used in various industries. many types of notches, particularly v-shaped notches, are sometimes used in the components made of plexiglass. these notches can dramatically decrease the load bearing capacity of components due to the concentration of s...

In this paper a new method to determine the fracture properties and strain energy release rate for Carbon- Polyester composite has been introduced.  Fracture characteristics such as critical stress intensity factor and critical strain energy release rate for mode I, mode II and mixed mode loading were determined using Arcan type specimen. 130 layers of carbon fiber polyester woven composite wit...

The purpose of this study was to investigate and analyse the fracture toughness of yttria stabilized tetragonal zirconia polycrystal (Y-TZP) dental ceramics by means of the Vickers indentation technique. Fracture toughness was analysed under the following loads: 29.42 N, 49.03 N, 196.13 N, and 294.20 N. Cracks that had developed from the vertices of a Vickers indentation were measured and used ...

Crack propagation along one of the interfaces between a thin ductile adhesive layer and the elastic substrates it joins is considered. The layer is taken as being elastic-plastic, and the fracture process of the interface is modeled by a traction-separation law, characterized by the peak separation stress 6 and the work of separation per unit area To. Crack growth resistance curves for mode I l...