Ti-6Al-4V triply periodic minimal surface (TPMS) structures with biomorphics scaffold designs are expected to be the most promising candidates for many biological applications such as bone implants. Fracture is the main failure mode of Ti-6Al-4V cellular structures at room temperature. However, there is currently less investigation on general analysis about the fracture mechanism of Ti-6Al-4V T...

By thermally cycling through their transformation temperature range, coarse-grained polymorphic materials can be deformed superplastically, owing to the emergence of transformation mismatch plasticity (or transformation superplasticity) as a deformation mechanism. This mechanism is presently investigated under biaxial stress conditions during thermal cycling of unalloyed titanium, Ti-6Al-4V, an...

UNLABELLED Femoral intramedullary implants were constructed by threading 4.0-millimeter-thick disks with a titanium-alloy (Ti-6Al-4V) porous bead coating onto a two-millimeter-diameter threaded rod. Each porous-coated disk, which was 6.0, 8.0, 9.0, or 10.0 millimeters in diameter, was separated by a two-millimeter-thick acrylic disk with a diameter of ten millimeters. Implants with and without ...

Abstract Implant infections associated with biofilm are a significant problem in current healthcare. Early detection of the development bacterial infection would allow deployment antibiotic treatment to suppress complications. Biofilm can be based on changes electrochemical response metal oxide sensor. The nanostructured surface titanium alloys provides large active/geometric area ratio and may...

Hydroxyapatite (HA) has been used in clinical bone graft procedures for the past 25 years. Although a biocompatible material, its poor adhesion strength to substrate makes it unsuitable for major loadbearing devices. Investigations on various deposition techniques of HA coating on Ti–6Al–4V implants have been made over the years, in particular to improve its adhesion strength to the metal alloy...

The present work introduces a novel extrusion with filler material to produce the high-performance TiBw/Ti-6Al-4V composite tube with a quasi-continuous reinforced structure. A simulation was adopted to study the effect of the filler material on the shape accuracy of the tubes. Based on the simulation results, the flow stress of the filler material was not the important factor, but the friction...

AIMS The aims of this study were to investigate the influence of commercially pure titanium (PTi) and titanium-aluminum-vanadium (Ti-6Al-4V) alloys (TiA) on the final shade of low-fusing porcelain bonded to them and to compare the shade changes with those of three conventional metal-ceramic systems. METHODS AND MATERIALS A titanium casting unit was used to cast PTi and Ti-6Al-4V alloy specime...

Purpose. The antimicrobial effect of a silver-coated tumor endoprosthesis has been proven in clinical and experimental trials. However, in the literature there are no reports concerning the effect of elementary silver on osteoblast behaviour. Therefore, the prosthetic stem was not silver-coated because of concerns regarding a possible inhibition of the osseointegration. The aim of the present s...

The purpose of this study was to evaluate the effect of heat treatments on the Vickers hardness of commercially pure titanium and Ti-6Al-4V cast alloys. Six-millimeter-diameter cylindrical specimens were cast in a Rematitan System. Commercially pure titanium and Ti-6Al-4V alloy specimens were randomly assigned to 3 groups (n=10) that received the following heat treatments: control (no heat trea...