Using experimental data acquired during a wind turbine measurement campaign, it is shown that amplitude modulation of aerodynamic noise can be generated by the rotating blades in conjunction with the atmospheric wind shear. As an attempt to alleviate this phenomenon, a control strategy is designed in form of a cyclic pitch of the blades. As a side effect, it is shown that it is also possible to...

It is difficult to conduct cyclic tensile fatigue tests for fine ceramics because of its high brittleness, and a little eccentricity of loading axis and gripping device gives inaccurate strength data. So, a major part of cyclic fatigue tests have been carried out under bending load conditions, for the allowance of misalignment of loading axis is generous to some extent in the case of bending fa...

Six formulas representing what is commonly referred to as “daily load stimulus” are identified, compared and tested in their ability to relate skeletal mechanical loading to bone maintenance and osteogenic response. Particular emphasis is placed on exerciseinduced skeletal loading and whether or not the formulas can adequately capture the known experimental observations of saturation of continu...

Low protein intake is associated with an alteration of bone microstructure and material level properties. However, it remains unknown whether these alterations of bone tissue could influence the response to repeated mechanical loading. The authors investigated the in vitro effect of repeated loading on bone strength in humeri collected from 20 6-month-old female rats pair-fed with a control (15...

In this paper, ratcheting behavior of beams subjected to mechanical cyclic loads at elevated temperature, using the rate dependent Chaboche unified viscoplastic model with combined kinematic and isotropic hardening theory of plasticity, is investigated. A precise and general numerical scheme, using the incremental method of solution, is developed to obtain the cyclic inelastic creep and plastic...

Article shows shear tests results for anchorage using bent foundation bolts 16, 24 and 36 mm in diameter torque-controlled undercut anchors 12, 16 20 diameter. Load-displacement diagrams were acquired loads static dynamic cyclic uncracked cracked concrete. Cyclic loading pattern simulated seismic on anchors. Shear allowed to estimate influence of cracks strength ductility anchorage.

BACKGROUND All-soft tissue suture anchors provide advantages of decreased removal of bone and decreased glenoid volume occupied compared with traditional tap or screw-in suture anchors. Previous published data have led to biomechanical concerns with the use of first-generation all-soft suture anchors. PURPOSE/HYPOTHESIS The purpose of this study was to evaluate the load to 2-mm displacement a...

Buckling restrained braced frames (BRBFs) for seismic load resistance have been widely used in recent years. One of the key requirements for a buckling restrained brace is to sustain large plastic deformations under severe ground motions. The core of a buckling restrained brace is prone to fatigue fracture under cyclic loading. The earthquake induced fracture type of the core plate in a bucklin...

Masonry infill has been widely used as building material due to its cost effectiveness and availability.  The failure of these masonry infill walls during the past earthquakes have underscored the importance of ensuring the safety of the infill walls when it is subjected to lateral loads. In-plane and out of plane failures have been observed in many reinforced concrete framed building with maso...

the aim of this research is to investigate the effect of carbon fiber reinforced polymer (cfrp) composite fabric on monotonic and fatigue behaviors of reinforced concrete beams. to control the failure occurrence, a small notch was induced at the middle span in bottom surface for all of the studied rc specimens. totally 12 beams were tested from which 6 beams tested under monotonic and 6 other t...