in this article, the effects of adding zn and conducting age hardening treatment on impression creep properties of mg-5%sn alloy have been investigated. the creep tests were carried out using impression creep method in which a cylindrical punch was used to apply the stress in range of 450 mpa < σimp < 270 mpa and at the test temperatures of 150, 175 and 200 °c. the results showed that age harde...

In two-phase TiAl-based alloys, the coexisting 2 and phases exhibit a thermal expansion mismatch, so that increased creep rates during thermal cycling may be expected. Creep deformation of two g-TiAl-based alloys was investigated during thermal cycles between 900 and 300 or 350 C with applied tensile stresses of 32.5 or 37.0 MPa. Measured thermal cycling creep rates were compared with isotherma...

Due to the importance effect of magnetic field on the history of long-term radial and circumfer-ential creep strain and radial displacement for a three-phase nano-composite exposed to an internal pressure and placed uniform temperature, the present article subject has been pro-posed. Three-phase nano-composite made of single-walled carbon nano tubes (SWCNTs)/ glass fiber (GF)/vinylester used to...

The purpose of this study is to evaluate the long-term vertical deformations of segmented pre-tensioned concrete bridges by a new approach. It provides a practical and reliable method for calculating the amount of long-term deformation based on creep and shrinkage in segmented prestress bridges. There are various relationships for estimating the creep and shrinkage of concrete. The analytical r...

Native collagen gels are important biomimetic cell support scaffolds, and a plastic compression process can now be used to rapidly remove fluid to any required collagen density, producing strong 3D tissue-like models. This study aimed to measure the mechanical creep properties of such scaffolds and to quantify any enhanced creep occurring in the presence of cells (cell-mediated creep). The test...

The effect of molybdenum (Mo) on the microstructure and creep behavior of nominally Ti–24Al– 17Nb (at.%) alloys and their continuously reinforced SiCfiber composites (fiber volume fraction = 0.35) was investigated. Constant-load, tensile-creep experiments were performed in the stress range of 10–275 MPa at 650 C in air. A Ti–24Al–17Nb–2.3Mo (at.%) alloy exhibited significantly greater creep res...

The creep behaviors of TA2 and R60702 at low and intermediate temperature were presented and discussed in this paper. Experimental results indicated that an apparent threshold stress exhibited in the creep deformation of R60702. Meanwhile, the primary creep phase was found as the main pattern in the room temperature creep behavior of TA2. Compared with exponential law, the power law has been pr...

Despite decades of intensive research, an entirely satisfactory constitutive relation for creep in concrete is still unavailable, even for working stress levels [I]. The rate-type creep laws with internal variables [2], although rather effective for numerical creep analysis of large structural systems, seem to be incapable of describing the aging phenomena without at least partially violating s...

The creep behavior of nanocellulose films and aerogels are studied in a dynamic moisture environment, which is crucial to their performance in packaging applications. For these materials, the creep rate under cyclic humidity conditions exceeds any constant humidity creep rate within the cycling range, a phenomenon known as mechanosorptive creep. By varying the sample thickness and relative humi...

In this article, experimental results on the effect of CO2 sorption and desorption on the creep response of polycarbonate (PC) are presented. Tensile specimens machined from PC sheets were exposed to CO2 and the absorbed gas mass fraction ranged from 0.045 to 0.12. The creep/creep recovery response of as-received PC, saturated PC, and saturation-cycled PC was characterized. It was found that th...