مظفر علی مهرابیان
دانشکده فنی، گروه مهندسی مکانیک، دانشگاه شهید باهنر کرمان
[ 1 ] - پیش‌بینی مقدار کل تابش خورشیدی در کرمان با استفاده از مشخصات هندسی، نجومی، جغرافیایی و هواشناسی.
در این پژوهش تأثیر موقعیت جغرافیایی و شرایط آب و هوایی بر میانگین مقدار کل روزانه‌ی تابش خورشیدی مورد بررسی قرار گرفت. برای این منظور از داده‌های اندازه‌گیری‌شده‌ی مربوط به مقدار کل تابش خورشیدی و همچنین مشخصات نجومی، جغرافیایی، هندسی و هواشناسی شهر کرمان که توسط سازمان هواشناسی ایران تهیه شده استفاده شد. تجزیه و تحلیل داده‌های تجربی نشان داد که میانگین روزانه‌ی مقدار کل تابش خورشیدی روی یک سطح...
[ 2 ] - Transient Characteristics of a Single-Effect Absorption Refrigeration Cycle
This paper deals with a lumped-parameter dynamic simulation of a single-effect LiBr-H2O absorption chiller. In many studies the thermodynamic properties of LiBr-H2O solution were taken from some approximate relations causing the results to be somewhat inaccurate. These relations were used to solve simultaneous differential equations involving the continuity of species constituting the LiBr-H2O ...
[ 3 ] - سنتز نانو حفره MCM-41 با استفاده از منبع سیلیس استخراج شده از گیاه جگن
گیاه جگن (Carex riparia) یک علف هرز بوده و یکی از پسماندهای کشاورزی به حساب می?آید. پس از استفاده از مواد آلی این گیاه به عنوان یک منبع انرژی در فرآیند احتراق، مواد بجای مانده غنی از سیلیس بوده که از لحاظ اقتصادی می?تواند یک ماده خام با ارزش جهت تولید مواد سیلیکاتی باشد. هدف این مطالعه بدست آوردن سیلیس خالص از گیاه جگن و همچنین سنتز ماده نانو حفره شش وجهی با ساختار منظم از نوع MCM-41 با استفاده...
[ 4 ] - Convective Heat Transfer from a Heated Rotating Disk at Arbitrary Inclination Angle in Laminar Flow
In this paper, experimental data and numerical results of heat transfer from a heated rotating disk in still air are presented over a large range of inclination angles and a dimensionless correlation is developed for forced, natural and mixed convection. The measured Nusselt number over the rotating disk is compared with the numerical results. The goal of the present research is to develop a se...
[ 5 ] - The Effects of an Imposed Magnetic Field on Natural Convection in a Tilted Cavity with Partially Active Vertical Walls:Numerical Approach
The effect of imposed magnetic field on natural convection in a tilted cavity with partially active walls was investigated numerically. The active part of the right side wall was at a higher temperature than the active part of the left side wall and were moving on vertical walls relative to each other. The top, the bottom and the remaining parts of the side walls were insulated. The magnetic fi...
[ 6 ] - Simulation of Ideal External and Internal Flows with Arbitrary Boundaries Using Schwarz Christoffel Transformation
The flow field, velocity and pressure coefficient distribution of some 2-D ideal flows are presented. Conformal mapping is used to simulate two-dimensional ideal flow for a variety of complex internal and external configurations, based on the numerical integration of Schwarz-Christoffel transformation. The advantages of this method are simplicity and high accuracy. The method presented in this ...
[ 7 ] - Computational Study of Radiative and Convective Heat Transfer in a Cylindrical Combustion Chamber
In this paper, the effect of cold air on the fluid flow inside the cylindrical combustion chamber and its wall temperature distribution have been studied computationally, taking into account the effect of radiative heat transfer from hot gases. The results have been compared with the case that radiative heat transfer was neglected. It is observed that the reattachment length increases when incr...
[ 8 ] - The Overall Heat Transfer Characteristics of a Double Pipe Heat Exchanger: Comparison of Experimental Data with Predictions of Standard Correlations
The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...
[ 9 ] - Feasibility Study of Solar Ejector Cooling Cycle in Different Weather Conditions
Today, renewable energies are of more interest due to depleting the ozone layer, increasing the cost of fossil fuels and friendliness with the environment. The sun is a great source of energy which is readily accessible. It has many applications in lighting, heating and cooling. In this study the thermal performance of a solar ejector cooling cycle is evaluated using several different working f...
نویسندگان همکار