Thin-film Encapsulation of Organic Light-Emitting Diodes Using Single and Multilayer Structures of MgF2, YF3 and ZnS
نویسندگان
چکیده مقاله:
In this research, the lifetime of green organic light emitting diodes (OLEDs) is studied using four passivation layers. To encapsulate the OLEDs, MgF2, YF3, composed of alternating MgF2/ZnS and YF3/ZnS layers were grown by thermal vacuum deposition. Measurements show that the device lifetime is significantly improved by using YF3 and ZnS as passivation layers. However, diodes encapsulated by MgF2/ZnS and YF3/ZnS nano-structures show a highly efficient gas diffusion barrier that results in a longer lifetime of the devices. The half lifetime of the green OLEDs reached 1200 minutes using YF3/ZnS layers. The electroluminescence (EL) and current-voltage characteristics of the devices were also examined to compare the electrical and the emissivity properties of the devices before and after encapsulation. This simple and inexpensive thin-film encapsulation method would be potentially employed to capsulate top emitting OLEDs and flexible OLEDs due to their good performance and easy fabrication.
منابع مشابه
Multilayer thin film encapsulation for organic light emitting diodes
A transparent and effective thin film encapsulation (TFE) based on a multilayer structure is demonstrated. Alternate films of amorphous and crystalline film forming organic materials have been investigated to create complicated diffusion pathways for oxygen and water vapour, which was reflected in their increased barrier properties. These layers are further protected by an inorganic barrier coa...
متن کاملOrganic thin film transistors and polymer light-emitting diodes
To fully realize the advantages of organic flexible electronics, patterning is very important. In this paper we show that a purely additive patterning technique, termed polymer inking and stamping, can be used to pattern conductive polymer PEDOT and fabricate sub-micron channel length organic thin film transistors. In addition, we applied the technique to transfer a stack of metal/conjugated po...
متن کاملThin film encapsulation for organic light-emitting diodes using inorganic/organic hybrid layers by atomic layer deposition
A hybrid nanolaminates consisting of Al2O3/ZrO2/alucone (aluminum alkoxides with carbon-containing backbones) grown by atomic layer deposition (ALD) were reported for an encapsulation of organic light-emitting diodes (OLEDs). The electrical Ca test in this study was designed to measure the water vapor transmission rate (WVTR) of nanolaminates. We found that moisture barrier performance was impr...
متن کاملEmission Characteristics of Organic Light-Emitting Diodes and Organic Thin-Films with Planar and Corrugated Structures
In this paper, we review the emission characteristics from organic light-emitting diodes (OLEDs) and organic molecular thin films with planar and corrugated structures. In a planar thin film structure, light emission from OLEDs was strongly influenced by the interference effect. With suitable design of microcavity structure and layer thicknesses adjustment, optical characteristics can be engine...
متن کاملA flexible organic active matrix circuit fabricated using novel organic thin film transistors and organic light-emitting diodes
We present an active matrix circuit fabricated on plastic (polyethylene naphthalene, PEN) and glass substrates using organic thin film transistors and organic capacitors to control organic light-emitting diodes (OLEDs). The basic circuit is fabricated using two pentacene-based transistors and a capacitor using a novel aluminum oxide/parylene stack (Al2O3/parylene) as the dielectric for both the...
متن کاملStudy of the Yellow Organic Light Emitting Diodes using ZnS/Metal/ZnS Multilayer Anodes and Investigation of the Effect of BCP on Electroluminescent Spectra of the Devices
The effects of ZnS/Metal/ZnS multilayer anodes, including ZnS/Au/ZnS (ZAuZ), ZnS/Ag/ZnS (ZAgZ) and ZnS/Cu/ZnS (ZCuZ) on device performance in organic light emitting diodes based on rubrene were investigated systematically. The device with ZAuZ as anode gave an improved performance comparable with ITO based devices. A low driving voltage of 5.61 V and a high luminance of 1836 cd/m were obtained ...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ذخیره در منابع من قبلا به منابع من ذحیره شده{@ msg_add @}
عنوان ژورنال
دوره 7 شماره None
صفحات 11- 18
تاریخ انتشار 2013-06
با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023