Preparation and Characterization of WO3 Electrochromic Films Obtained by the Sol-Gel Process

نویسندگان

  • Abdoljavad Novinrooz Material and Ion Beam Application Division, Nuclear Research Center, P. O. Box 31485-498, Karaj, I.R. IRAN
  • Hassan Noorkojouri Material and Ion Beam Application Division, Nuclear Research Center, P. O. Box 31485-498, Karaj, I.R. IRAN
  • Masoomeh Sharbatdaran Material and Ion Beam Application Division, Nuclear Research Center, P. O. Box 31485-498, Karaj, I.R. IRAN
چکیده مقاله:

Tungsten trioxide (WO3) films have been coated on indium thin oxide (ITO) conductive glass substrate, using aqueous solution of peroxotungstic acid (PTA) by the sol-gel dip coating method. X-ray diffractometery (XRD) analysis confirmed monoclinic and triclinic structure for the film and powdered WO3 respectively. Fourier transforms infrared spectroscopy (FT-IR) exhibited the structure of peroxotungstic acid. The SEM micrograph of annealed species revealed micro cracks due to decrease of density and contraction of layers. Energy- dispersive X-ray (EDX) study determined 1:3 ratios of oxygen and tungsten atoms in the prepared films at heat treatment temperature higher than 200ºC. The electrochromical behavior was investigated in 1M HCL solution employing cyclic voltammetry. It was found that WO3 films demonstrated good reversibility at 200 ºC.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

preparation and characterization of wo3 electrochromic films obtained by the sol-gel process

tungsten trioxide (wo3) films have been coated on indium thin oxide (ito) conductive glass substrate, using aqueous solution of peroxotungstic acid (pta) by the sol-gel dip coating method. x-ray diffractometery (xrd) analysis confirmed monoclinic and triclinic structure for the film and powdered wo3 respectively. fourier transforms infrared spectroscopy (ft-ir) exhibited the structure of peroxo...

متن کامل

Preparation and characterization of ZnO-TiO2 films obtained by sol-gel method

The sol-gel route has been applied to obtain ZnO-TiO2 thin films. For comparison, pure TiO2 and ZnO films are also prepared from the corresponding solutions. The films are deposited by a spin-coated method on silicon and glass substrates. Their structural and vibrational properties have been studied as a function of the annealing temperatures (400-750 °C). Pure ZnO films crystallize in a wurtzi...

متن کامل

Preparation of WO3 Thin Films for Electrochromic Display by Plasma Process

Tungsten oxide (WOx) thin film, which is well known as an electrochromic display, was deposited on the ITO film coated flexible substrates using the RF magnetron sputtering method. Phenomena of processing plasmas, the film quality and the electrochromic properties of deposited WO3 thin film have been studied as parameters of a gas pressure and gas mixture. Experimental results suggest that depo...

متن کامل

Characterization of Pure and Antimony Doped SnO2 Thin Films Prepared by the Sol-Gel Technique

Pure and antimony doped SnO2 thin films have been prepared by the sol-gel dip coating technique on glass substrate using starting material SnCl2.2H2O as a host and SbCl3 as a dopant. Our experimental results revealed that, the quality of the coated films on the glass depends on process parameters. The effect of annealing temperature, dipping numbe...

متن کامل

Synthesis and Characterization of Nb2O5:La,Eu Phosphors Obtained by the Non‐Hydrolytic Sol‐Gel Process

The phosphor-converted light-emitting diode technique is an important solid-state illumination strategy. Sulfide-based materials are the most often employed red phosphors, but they are chemically unstable and present lower efficiency in comparison to the blue and green phosphors. Therefore, it is important to find a new red phosphor source that can emit intense red light while absorbing light i...

متن کامل

Preparation and luminescent properties of Eu- doped BaTiO3 thin films by sol–gel process

Eu-doped BaTiO3 thin films with a pseudo-cubic perovskite structure were successfully fabricated on magnesia substrates at low temperature by using a high-concentration sol–gel process, in which the newly developed gel-aging process on substrate was employed. Film microstructure, crystallinity, sintering properties and photoluminescence (PL) were investigated. The xerogel thin films exhibited s...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 25  شماره 2

صفحات  25- 29

تاریخ انتشار 2006-06-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023