Enhanced Anti-corrosive Properties of Electrosynthesized Polyaniline/zeolite Nanocomposite Coatings on Steel

نویسندگان

  • Elaheh Allahyary Department of Analytical Chemistry, Faculty of Chemistry, University of Kashan, Kashan, Iran
  • Yasser Jafari Department of Analytical Chemistry, Faculty of Chemistry, University of Kashan, Kashan, Iran
چکیده مقاله:

The preparation of polyaniline/zeolite nanocomposite coating on 304 stainless steel (304 SS) surface has studied via the galvanostatic method. The electro-generated coating was characterized by Fourier transform infrared spectroscopy (FT-IR), UV-visible absorption spectroscopy, X-ray diffraction (XRD) patterns and scanning electron microscopy (SEM). The anticorrosion property of polyaniline/zeolite nanocomposite coating was explored in 0.5 M hydrochloric acid solution by Tafel polarization method and electrochemical impedance spectroscopy (EIS). The effect of variable parameters such as the applied current density and deposition time on the corrosion protection of the electro-generated coatings was also considered. The corrosion rate of coated-304 SS was releazied about 36 times lower than bare 304 SS. Potential of corrosion also changed from -0.411 V to -0.279 V versus Ag/AgCl for un-coated and coated-304 SS electrodes, respectively. Electrochemical measurements indicate that polyaniline/zeolite nanocomposite coated on 304 SS has remarkable inhibitive properties with protection effectiveness of ~97% at 2.5 mA cm-2 current density used on 304 SS in acidic medium. The outcomes of this research obviously find out that the polyaniline/zeolite nanocomposite has an outstanding possible to defend 304 SS against corrosion in an acid environment.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Anti-corrosive Properties of CeO2 Conversion Coatings on Aluminum Alloy 2024 Prepared by Dip Immersion Method

As an alternative to chromate conversion coatings, rare-earth coatings especially cerium, because of the low toxicity, have attracted considerable attention. Using dip immersion method, cerium-based conversion coating was deposited on aluminum 2024. Corrosion resistance was studied in 3.5 wt.% NaCl solution using potentiodynamic polarization, electrochemical impedance spectroscopy, and surface ...

متن کامل

anti-corrosive properties of ceo2 conversion coatings on aluminum alloy 2024 prepared by dip immersion method

as an alternative to chromate conversion coatings, rare-earth coatings especially cerium, because of the low toxicity, have attracted considerable attention. using dip immersion method, cerium-based conversion coating was deposited on aluminum 2024. corrosion resistance was studied in 3.5 wt.% nacl solution using potentiodynamic polarization, electrochemical impedance spectroscopy, and surface ...

متن کامل

Mechanical Aspects of Anti - Corrosive Coatings Performance Tests

Protective coating corrosion failure is a complicated process that involves various phenomena which are hard to test for separately. An adequately protected pipe can be in service for a relatively long time without exhibiting any signs of corrosion failure, and then all of a sudden it corrodes over a short period of time. Failure will definitely happen if the interface between the pipe surface ...

متن کامل

Biofunctionalized anti-corrosive silane coatings for magnesium alloys.

Biodegradable magnesium alloys are advantageous in various implant applications, as they reduce the risks associated with permanent metallic implants. However, a rapid corrosion rate is usually a hindrance in biomedical applications. Here we report a facile two step procedure to introduce multifunctional, anti-corrosive coatings on Mg alloys, such as AZ31. The first step involves treating the N...

متن کامل

Comparison Studies on Corrosive Properties of Polyester Filled Graphene Primer Coatings via Sonication and Mechanical Method

This paper investigates the mixing of the graphene (GR) particles in the polyester (PE) resin by using two different dispersion techniques which are mechanical stirring and sonication method. This paper shows that the mixing method has a significant effect on the corrosive behavior of the coatings. Fourier Transform Infrared Spectroscopy (FT-IR) characterization technique is done to analyze...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 8  شماره 2

صفحات  131- 143

تاریخ انتشار 2018-04-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023