Computational fluid dynamics simulations for investigation of parameters affecting goaf gas distribution

نویسندگان

  • R.S. Balusu Energy Flagship, CSIRO, Pullenvale, Kenmore, Australia
چکیده مقاله:

It is necessary to obtain a fundamental understanding of the goaf gas flow patterns in longwall mine in order to develop optimum goaf gas drainage and spontaneous combustion (sponcom) management strategies. The best ventilation layout for a longwall underground mine should assist in goaf gas drainage and further reduce the risk of sponcom in the goaf. Further, in the longwall panel, regulators are installed in the maingate (MG) seals to control the gas migration on the MG side and the mine operators frequently encountered with seals leakage problems leading to abnormal gas contents in the tube bundles. Extensive parametric studies were carried out to investigate the effects of ventilation layouts, regulators, and seals leakages on the goaf gas distribution using the Computational Fluid Dynamics (CFD) techniques. The results of various CFD simulations are presented and discussed in detail in this paper.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Computational fluid dynamics simulations of ship airwake

Computational fluid dynamics (CFD) simulations of ship airwakes are discussed in this article. CFD is used to simulate the airwakes of landing helicopter assault (LHA) and landing platform dock-17 (LPD-17) classes of ships. The focus is on capturing the massively separated flow from sharp edges of blunt bodies, while ignoring the viscous effects. A parallel, finitevolume flow solver is used wit...

متن کامل

Investigation on thermal behavior of common types of roofs in buildings using computational fluid dynamics method

In this study, the influence of type and structure of different roofing systems were investigated using computational fluid dynamic method. The considered roofing systems include beam and block types (clay brick, light weight concrete block, polystyrene) and Uboot slab which were designed for 6m and 8m span. To simulate the fluid flow and heat transfer, the computational fluid dynamic method wa...

متن کامل

Validation of Computational Fluid Dynamics Simulations for Realistic Flows

Strategies used to verify and validate computational fluid dynamics (CFD) calculations are described via case studies of realistic flow simulations, each representing a complex flow physics and complex geometry. Critical areas of importance to validation of a calculation are pointed out through various high fidelity physicsand engineering-based simulations. These areas include the physical mode...

متن کامل

Investigation of stepped planning hull hydrodynamics using computational fluid dynamics and response surface method

The use of step at the bottom of the hull is one of the effective factors in reducing the resistance and increasing the stability of the Planning hull. The presence of step at the bottom of this type of hulls creates a separation in the flow, which reduces the wet surface on the hull, thus reducing the drag on the body, as well as reducing the dynamic trim. In this study, a design space was cre...

متن کامل

Investigation of handmade ferrofluids' motion in a ventilated cavity using computational fluid dynamics

In this research, some more applicable ferrofluids are produced and their mechanical specifications are measured, experimentally. Also, their treatments in the ventilated cavity geometry are assessed numerically. The magnetite nanoparticles are produced by a chemical combination of Fe2+ and Fe3+ with NH3. In order to solve the nanoparticles in the new mediums, a...

متن کامل

Investigation of handmade ferrofluids' motion in a ventilated cavity using computational fluid dynamics

In this research, some more applicable ferrofluids are produced and their mechanical specifications are measured, experimentally. Also, their treatments in the ventilated cavity geometry are assessed numerically. The magnetite nanoparticles are produced by a chemical combination of Fe2+ and Fe3+ with NH3. In order to solve the nanoparticles in the new mediums, a...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 9  شماره 3

صفحات  547- 557

تاریخ انتشار 2018-07-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023