A Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers

A W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm

A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...

A Novel and Single Chip Tri-band Low- Noise Amplifier for Wlan, Wifi and Wimax Receivers

In first stage of each microwave receiver there is Low Noise Amplifier (LNA) circuit, and this stage has important rule in quality factor of the receiver. The design of a LNA in Radio Frequency (RF) circuit requires the trade-off many importance characteristics such as gain, Noise Figure (NF), stability, power consumption and complexity. This situation forces designers to make choices in the de...

Design of an S-band Ultra-low-noise Amplifier with Frequency Band Switching Capability

In this paper, an ultra-low-noise amplifier with frequency band switching capability is designed, simulated and fabricated. The two frequency ranges of this amplifier consist of the 2.4 to 2.5 GHz and 3.1 GHz to 3.15 GHz frequency bands. The designed amplifier has a noise figure of less than 1dB, a minimum gain of 23 dB and a VSWR of less than 2 in the whole frequency band. The design process s...

Ultra Wide Band Low Noise Amplifier for Communication Receivers in 0 . 18 μ m CMOS technology

This paper presents an inductorless low-noise amplifier (LNA) design for an ultra-wideband (UWB) receiver frontend. A current-reuse gain-enhanced noise canceling architecture is proposed, and the properties and limitations of the gainenhancement stage are discussed. Capacitive peaking is employed to improve the gain flatness and 3-dB bandwidth, at the cost of absolute gain value. The LNA circui...

A Miniaturized Monolithic 2.4/5.7 GHz Concurrent Dual-Band Low Noise Amplifier Using InGaP/GaAs HBT Technology

This paper presents the design and experimental results of a miniaturized monolithic 2.4/5.7 GHz concurrent dual-band low noise amplifier with cascade configuration using InGaP/GaAs HBT technology for the first time. The first stage of the LNA provides high gain and input matching simultaneously at both 2.4 GHz and 5.7 GHz bands. The output matching of the second stage is realized by shunt-shun...

A CMOS Multi-band Low Noise Amplifier for WiMAX Applications