شماره 1 تاریخ انتشار 2005-07

• A New Generation Allocation and Expansion Planning Algorithm Including Transmission System Effects
• Performance Improvement of Radar Target Detection by Wavelet-based Denoising Methods
• A New Heuristic Algorithm for Time-cost Trade-off Problem Taking into Account Monetary Value
• An Efficient Algorithm for Reducing the Duality Gap in a Special Class of the Knapsack Problem
• The Effect of Station Density and Regional Division on Spatial Distribution of Daily Rainfall
• Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data
• Forced Hydraulic Jump by One and Two Continuous Sills in a Horizontal Stilling Basin.
• Behavior of Castellated I Beams Encased in Concrete
• Evaluation of Optimum Landfill Design by Contaminant Transport Analysis
• investigation of Parameters Affecting Abrasion Resistance of R.C.C.
• Effects of Support Conditions on Dynamic Behaviour and Seismic Response of Ghadir Bridge
• Square Joints in Railway Track Waves
• Numerical and Experimental Analysis of the Effect of Flow Discharge Ratio on Flow Separation at 45 Degree Open End Water Intake
• A New Implicit Dissipation Term for Solving 3D Euler Equations on Unstructured Grids by GMRES+LU-SGS Scheme
• Hydrodynamic Resistance Reduction in Catamaran Assisted Hydrofoils
• Stability Analysis for Wake Flow Behind a Flat Plate
• Investigations on Cold Rolling of Strip in Attendance of Hydrodynamic Lubrication
• Temperature Distribution of a Non gray Gas between Two Parallel Planes Using Exponential Wide Band Model
• Heat Transfer from a Tube Bank in Cross Flow in a Duct
• Microstructural Effect on the Weldability of 25Cr-35Ni Cast Steel
• Optimization of Reductive Leaching of Tidar Cobalt Ore Using Taguchi Method
• Hot Mercerizing of Cotton/Polyester Blend Fabric Effect of Alkali Treatment Temperature on Ttensile Properties , Weight Loss and Shrinkage of Fabric
• Effects of Changes in Front Drafting Rollers Geometry on the Properties of Ring Spun Yarns
• Analysing of Continuous Welded Turnouts
• Analysis of Thin-Walled Steel Sections Filled with Concrete Using Non-Linear Finite Element Method
• Effect of Limestone Powder on Compressive Strength of Concrete Containing Silica Fume and Optimization of Mix Design Using Response Surface Method
• Thermo-economic Analysis of Power Cycles
• Effects of Coating Golegohar-Chadormalu Pellet on Its Behaviour in Direct Reduction Process