A. R. Eivani
Materials Processing Simulation Laboratory (MPS – Lab), School of materials and metallurgical engineering, Iran University of science and technology (IUST), Narmak, Tehran, Iran.
[ 1 ] - Workability study in near-pritectic Sn-5%Sb lead-free solder alloy processed by severe plastic deformation
Prediction of the deformation characteristics is an important step to understand the workability of alloys during imposing large strains. In this research, severe plastic deformation of Sn-5Sb solder alloy was carried out under different t deformation conditions, including the temperature range of 298, 330, 36, 400 K and die designs. The current study applies an experimentally validated finite ...
[ 2 ] - Re-strengthening in AA6063 Alloy During Equal Channel Angular Pressing
Equal channel angular pressing (ECAP) is carried out using two different configurations for the exit channel of the ECAP die, i.e., relieved and choked, with angles of 0.2 °. It is found that using a die with relieved exit channel, the sample was extruded for 6 passes with no surface cracks and an average cell size of 727 nm and a fraction of high angle grain boundaries of 54 % were achieved. M...
[ 3 ] - Effect of Equal Channel Angular Pressing and Annealing Treatment on the Evolution of Microstructure in AlMg0.7Si Aluminum Alloy
In this research, samples of AlMg0.7Si aluminum alloy are deformed up to three passes using equal channel angular pressing (ECAP). Formation of a sub-micron structure after three passes of ECAP is demonstrated. Microstructural stability of the samples is investigated at temperatures of 300-500 °C. At 300 °C, fine recrystallized structure forms after 10 min which remains stable when the ...
[ 4 ] - EFFECT OF POST-DEFORMATION ANNEALING TREATMENT ON INTERFACE PROPERTIES AND SHEAR BOND STRENGTH OF Al-Cu BIMETALLIC RODS PRODUCED BY EQUAL CHANNEL ANGULAR PRESSING
Effects of annealing treatment after equal channel angular pressing (ECAP) on the interface properties and shear bond strength of Al/Cu bimetallic rods were investigated. For the as-deformed samples, the one with two passes of ECAP indicated higher shear bond strength. Formation of a layer of intermetallic compounds after annealing treatment is confirmed. In general, by increasing annealing tem...
[ 5 ] - مطالعه ریزساختاری و خواص مکانیکی درحین فرایند جوشکاری اصطکاکی اختلاطی در فولاد فریتی کم کربن
در مقاله حاضر، تغییرات ریزساختاری و خواص مکانیکی در حین فرایند جوشکاری اصطکاکی اختلاطی با سرعت های دورانی و پیشروی متفاوت به وسیله تست‌های کشش، سختی سنجی و متالوگرافی مورد بررسی قرار گرفت. جوشکاری توسط دستگاه فرز سنگین توسط دستگاه فرز سنگین بر روی فولاد کم کربن فریتی انجام شد. بررسی های ریزساختاری توسط میکروسکوپ نوری و میکروسکوپ الکترونی روبشی انجام شدند. نتایج حاصل از این تحقیق نشان داد که در...
Co-Authors