THE OXIDATION RESISTANCE OF HIGH ALUMINUM HEAT RESISTANT STEELS
Authors
Abstract:
Abstract: In this research, the oxidation behaviour of high Aluminum heat resistant steel (%25Cr,%20Ni,%8Al) hasbeen evaluated at the temperature range of (1000-1300ºC).The results showed that there was no countinous healinglayer on the surface of the alloy when Al increased up to %5.5 and the oxidation resistance of steel decreased due toformation of spinel oxides on the surface.By increasing the aluminum amount to %8, only Al oxide formed due to decreasing carbon potential of thealloy,homogenity of elemental concentration in matrix and no diffusion of oxygen through oxide–metalinterface,therefore it has superior oxidation resistance. Meanwhile,oxidation tests showed that the weight gain of thesteel at high temperature oxidation even at 1300ºC was too low.
similar resources
High heat flux testing of 12–14Cr ODS ferritic steels
0022-3115/$ see front matter 2009 Published by doi:10.1016/j.jnucmat.2009.09.022 * Corresponding author. E-mail address: [email protected] (Z. Oksiut The thermal performance of Fe–(12–14)Cr–2W–0.3Ti–0.3Y2O3 ODS reduced activation ferritic steels, which are considered as candidate first wall materials for the future fusion power reactors and were manufactured by mechanical alloying in hydr...
full textOxidation of aluminum nanoclusters
Timothy J. Campbell,1,2 Gurcan Aral,1 Shuji Ogata,3 Rajiv K. Kalia,1 Aiichiro Nakano,1 and Priya Vashishta1 1Collaboratory for Advanced Computing and Simulations, Department of Materials Science and Engineering, Department of Physics and Astronomy, Department of Computer Science, University of Southern California, Los Angeles, California 90089-0242, USA 2Mississippi State University, Stennis Sp...
full textEFFECT OF HIGH TEMPERATURE OXIDATION ON THE CORROSION BEHAVIOR OF ALUMINIZED LOW CARBON STEEL IN MOLTEN ALUMINUM
Hot dip aluminizing was carried out on the low carbon steel rod under optimized conditions. The aluminized samples were further oxidized at 1000̊C in air atmosphere at two different times of 20 and 60 minutes. Microstructure study and phase analysis were studied by scanning electron microscopy and X-ray diffraction methods, respectively. The characterization of the coating showed that, Fe2...
full textHigh Manganese and Aluminum Steels for the Military and Transportation Industry
Lightweight advanced high strength steels (AHSS) with aluminum contents between 4 and 12 weight percent have been the subject of intense interest in the last decade because of an excellent combination of high strain rate toughness coupled with up to a 17% reduction in density. Fully austenitic cast steels with a nominal composition of Fe-30%Mn-9%Al-0.9%C are almost 15% less dense than quenched ...
full textHigh-Strength Bainitic Steels
With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...
full textthe impact of musical texts on the text recall of young learners of english in isfahan junior high schools
abstract although music possesses some kind of power and using it has been welcome by many students in language classrooms, it seems that they take a non-serious image of the lesson while listening to songs and they may think that it is a matter of fun. the main objective of the present study was to investigate whether learning a foreign language through musical texts (songs) can have an impac...
15 صفحه اولMy Resources
Journal title
volume 6 issue 3
pages 21- 28
publication date 2009-09
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023