FSR Decrement and Coupling Coefficient Increment in Add-Drop Filters
Authors
Abstract:
In this paper, effects of the structural parameters on the optical characteristics of an add-drop filter, consisting of two straight waveguides and a micro-ring resonator (MRR), have been investigated. In this research, effects of MRR radius, the width of MRR and waveguide and the gap between MRR and waveguide, on free spectral range (FSR) and coupling coefficient have been studied. It is found thatby enhancing the gap and width, coupling coefficient would be increased at first but after a while it would be decreased. It is also shown that, increasing the radius and width would decrease FSR. The main goal of this research is to decrease FSR and increase the coupling coefficient of add-drop filters, which are widely used in communication applications.
similar resources
FSR Decrement and Coupling Coefficient Increment in Add- Drop Filters
ARTICLE HISTORY: Received 15 February 2015 Revised 10 April 2015 Accepted 14 April 2015 In this paper, effects of the structural parameters on the optical characteristics of an add-drop filter, consisting of two straight waveguides and a micro-ring resonator (MRR), have been investigated. In this research, effects of MRR radius, the width of MRR and waveguide and the gap between MRR and wavegui...
full textfsr decrement and coupling coefficient increment in add-drop filters
in this paper, effects of the structural parameters on the optical characteristics of an add-drop filter, consisting of two straight waveguides and a micro-ring resonator (mrr), have been investigated. in this research, effects of mrr radius, the width of mrr and waveguide and the gap between mrr and waveguide, on free spectral range (fsr) and coupling coefficient have been studied. it is found...
full textMode-Coupling Analysis of Multipole Symmetric Resonant Add/Drop Filters
Time-dependent mode-coupling theory is used to analyze a type of resonant add/drop filter based on the excitation of degenerate symmetric and antisymmetric modes. Flat-top transfer functions are achieved with higher order filters that utilize multiple resonator pairs, designed to satisfy the degeneracy conditions. The resulting analytic expressions lead to an equivalent circuit and the transfer...
full textCoupling of Modes Analysis of Resonant Channel Add–Drop Filters
The operation principle of resonant channel add–drop filters based on degenerate symmetric and antisymmetric standing-wave modes has been described elsewhere using group theoretical arguments. In this paper, the analysis is carried out using coupling of modes in time. A possible implementation of such a filter is a four-port system utilizing a pair of identical single-mode standing wave resonat...
full textAdd-Drop and Channel-Drop Optical Filters Based on Photonic Crystal Ring Resonators
Here, we propose an add-drop and a channel drop filter based on two-dimensional photonic crystal all circular ring resonators. These structures are made of a square lattice of silicon rods with the refractive index n1=3.464 surrounded by air (with refractive index n2=1). The broadest photonic band gap occurs at the filling ratio of r/a = 0.17. Two linear defect W1 waveguides couple to the ring....
full textApodised Bragg gratings in planar waveguides for add-drop filters
We report on the fabrication by electron-beam lithography of Bragg gratings, which serve as wavelength-selective elements of a Mach–Zehnder-type add-drop filter. To meet telecommunication network requirements, the gratings must have about 20 000 lines, corresponding to a length on the order of 10 mm. Furthermore, the coupling strength of the gratings has to be varied according to a bell-shaped ...
full textMy Resources
Journal title
volume 3 issue 1
pages 13- 16
publication date 2015-06-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023