Early Age Shrinkage Behavior of Triple Blend Concrete

Authors

  • M. Murmu Department of Civil Engineering, National Institute of Technology Raipur, Chhattisgarh, India
  • S. V. Deo Department of Civil Engineering, National Institute of Technology Raipur, Chhattisgarh, India
  • V. N. Kanthe Department of Civil Engineering, National Institute of Technology Raipur, Chhattisgarh, India
Abstract:

The early age shrinkage is responsible for the early age cracking of concrete. It is very critical for durability of concrete. The change in volume of concrete due to evaporation of water or dehydration process is known as shrinkage. To reduce the early age shrinkage utilized the supplementary cementitious material (SCM) in concrete. In present research industrial and agricultural waste byproduct like fly ash (FA) and rice husk ash (RHA) along with cement were used as SCM. The triple blend concrete was prepared by the combination of 20%, 30% and 40% partial cement replacement with FA and RHA for 0.30, 0.35 and 0.40 water-cement ratio. The concrete samples were tested by advanced  instrument as shrinkage cone meter were used for measure the shrinkage. The result shows that the early age shrinkage reduced with increasing the SCM content. The microstructure characteristics enhanced with raising the content of FA and RHA up to 30% replacement; that was due to the dense particle packing.

Upgrade to premium to download articles

Sign up to access the full text

Already have an account?login

similar resources

Lattice Modeling of Early-Age Behavior of Structural Concrete

The susceptibility of structural concrete to early-age cracking depends on material composition, methods of processing, structural boundary conditions, and a variety of environmental factors. Computational modeling offers a means for identifying primary factors and strategies for reducing cracking potential. Herein, lattice models are shown to be adept at simulating the thermal-hygral-mechanica...

full text

Shrinkage of High Strength Concrete

This paper presents the results of an experimental investigation carried out to evaluate the shrinkage of High Strength Concrete. High Strength Concrete is made by partially replacement of cement by flyash and silica fume. The shrinkage of High Strength Concrete has been studied using the different types of coarse and fine aggregates i.e. Sandstone and Granite of 12.5 mm size and Yamuna and Bad...

full text

Health Monitoring of Early Age Concrete

The setting and hardening process of concrete can be considered as the most critical time period during the life of a concrete structure. To assure high quality and avoid problems in performance throughout the life of the material, it is essential to have reliable information about the early age properties of the concrete. This paper presents a new method to monitor the hydration process of cem...

full text

Drying shrinkage of concrete made from recycled concrete aggregate

Recycled concrete aggregates (RCA) are used in new concrete mixes, termed recycled aggregate concrete (RAC). Among losses in most fresh and hardened properties, literature reports that RAC suffers increased levels of drying shrinkage compared to equivalent mixes incorporating conventional aggregates. This paper describes the procedure and results of a range of experiments conducted on a commerc...

full text

Effect Of Water/Cement Ratio And Curing Temperature On Early-Age Shrinkage And Self-Induced Stresses Of High Performance Concrete

This paper presents the results of an experimental study dealing with the influence of water/cement (w/c) ratio and curing temperature on the autogenous deformations and self-induced stresses in early-age concrete. Two concrete mixes, w/c ratio 0.33 and 0.37, were cured isothermally at 10, 20, 30 and 40°C. The linear deformations of a free specimen and the self-induced stresses of a fully restr...

full text

My Resources

Save resource for easier access later

Save to my library Already added to my library

{@ msg_add @}


Journal title

volume 33  issue 8

pages  1459- 1464

publication date 2020-08-01

By following a journal you will be notified via email when a new issue of this journal is published.

Hosted on Doprax cloud platform doprax.com

copyright © 2015-2023