Design Supplementary Controller Based on Stabilizing Effect of Delay for Damping Inter Area Oscillations in a Power System

Damping of Power System Oscillations Using SSSC - based Supplementary controller

Power-system stability improvement by a static synchronous series compensator (SSSC)-based controller is studied in this paper. Conventionally, the lead-lag structure was used to modulate the injected voltage. But, in this paper, PID controller is also considered. The design problem of the proposed controller is formulated as an optimization problem and Differential Evolution Algorithm is used ...

Damping Controller Design for Power System Oscillations

Satisfactory damping of power oscillations is an important issue to be addressed when dealing with the angle stability of power systems. This phenomenon is well-known and observable especially when a fault occurs. To improve the damping of oscillations in power systems, supplementary control laws can be applied to existing devices. These supplementary actions are referred to as power oscillatio...

A Robust FACTS Damping Controller Design to Mitigate Interarea Oscillations in a Multi-machine Power System

In this paper, damping of interarea oscillations using simultaneous coordination of static Var compensator (SVC) and power system stabilizer (PSS) is considered.  To be effective in damping of oscillations, the best-input signal of power oscillation damper (POD) associated with SVC is selected using Hankel singular values (HSVs), and right-hand plane zeros (RHP-zeros). The 4-machine-2 area...

Design of Wide-area Damping Control Systems for Power System Low-frequency Inter-area Oscillations

Delay-Scheduled Controllers for Inter-Area Oscillations Considering Time Delays

Unlike the existing views that was introduced the existence of delay caused by the transmission of wide area measurement system data (WAMS) into the controllers input of the power oscilation damping (POD) by communication networks as a reason for poor performance of the POD controllers. This paper shows that the presence of time delay in the feedback loop may improve the performance of a POD co...

Robust Controller for Damping Power System Oscillations

Design of power system stabilizer using Linear Quadratic Regulator (LQR) technique. Designs that ignore noise in a plant are likely to fail when implemented in actual conditions. Presence of the noise, which results in LQR output oscillating with very small magnitude. This type of unwanted noisy output is eliminated using Linear Quadratic Gaussian (LQG) Regulator. This paper presents techniques...