Design Servo System Type and Positioning of Pole Observer Full Rank a Piezoelectric Servo Valve without Integrator
Authors
Abstract:
In this paper, the method of modern control approach for the design of controller and observer is used. Other functions such as neural controllers - or fuzzy sliding mode control can be found in this work and the results are compared. First, a dynamic model of the servo valve is intended for the governing equations in state-space form expression are obtained. Due to the system integrator is expressed by the non-zero, The servo system of a full-order state observer pole positioning method to measure the dominant pole, Bessel and ITAE is designed and evaluated. Response to a step input to the system is designed and the observer's response to initial conditions. The curves show the comparison between systems is designed to do.
similar resources
A Full Adaptive Observer for DC Servo Motors
An adaptive observer estimating all parameters and load torque is proposed for DC servo motors. The observer uses no direct feedback but the adaptation schemes use current and speed measurements. Both the observer and adaptations are simple to implement for real-time applications. Simulation results are satisfactory for the full adaptive observer. If the observer works in parallel with only loa...
full textProportional and Servo Valve Technology
8 • Fluid Power Journal March/April 2003 The ability to achieve automated stepless control of pressure and flow rate in fluid power systems has undergone major development in the past twenty-five years. Electrohydraulic servo valves were invented in the late 1930s as a high tech, though high cost, solution to motion control needs. The mid-1980s saw the practical introduction of proportional val...
full textPositioning Control of Pneumatic Servo System with Pressure Control Loop Using Disturbance Observer
This paper describes one method to attain a robust positioning control of pneumatic driving system comprising a pneumatic cylinder and PCM digital control valves. A pneumatic driving system has become one of interests in the industrial fields, however, the control characteristics are inevitably affected by the friction force and parameter changes of plant due to air compressibility. The control...
full textProportional and Servo Valve Technology
8 • Fluid Power Journal March/April 2003 The ability to achieve automated stepless control of pressure and flow rate in fluid power systems has undergone major development in the past twenty-five years. Electrohydraulic servo valves were invented in the late 1930s as a high tech, though high cost, solution to motion control needs. The mid-1980s saw the practical introduction of proportional val...
full textElectro-hydraulic Servo Valve Systems
Hydraulic systems driven by servo valves provide highly accurate control over enormous forces. A servo valve system consists of a transducer, a servo amplifier, a servo valve, and an actuator with a connected load. It is a closed-loop system used for the precise control of the output (load) parameter, such as position, velocity, or force, in response to a command signal. The output is converted...
full textControl System Design of a Pneumatic Servo System
Pneumatic servo systems are applied in several industrial applications and have also been studied extensively for the purposes of compensating the nonlinearity of pneumatic servo systems and improving the controllability with robust control. In their control system design, the transfer function of a pneumatic servo system has been a third-order time lag system, based on the assumption that serv...
full textMy Resources
Journal title
volume 7 issue 1
pages 43- 52
publication date 2014-06-22
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023