Core Loading Design for Bushehr Pressurized Water Reactor
author
Abstract:
The modified out-in fuel management strategy was applied to the core loading design for the first four cycles of the Bushehr (Iran-1) KWU designed Pressurized Water Reactor (PWR). The minimum peak-to-average power density was chosen as the objective function of the optimization process. Lattice homogenization and group constants generation were performed by using the LEOPARD computer code. For core calculations the ERUPT code was applied. The optimum core configurations were designed after several hand shufflings of fuel assemblies. For the equilibrium cycle, a satisfactory value of 2.73 was found for the peaking power factor. The average discharge burn-up of this cycle was determined to be around 33,700 MWD/MTU.
similar resources
Thermal-Hydraulics analysis of pressurized water reactor core by using single heated channel model
Thermal hydraulics of nuclear reactor as a basis of reactor safety has a very important role in reactor design and control. The thermal-hydraulic analysis provides input data to the reactor-physics analysis, whereas the latter gives information about the distribution of heat sources, which is needed to perform the thermal-hydraulic analysis. In this study single heated channel model as a very f...
full textPressurized Water Reactor Modelling with Modelica
In order to optimize and validate the design and the operation of its nuclear power plants facilities, EDF (Electricité de France) uses a proprietary tool called LEDA to perform static and dynamic simulation at the system level. EDF wishes to replace LEDA by state-of-the-art off-the-shelf tools, mainly to reduce maintenance cost while keeping up with the latest trend in modeling and simulation ...
full textNeural Network Controller for the Pressurized Water Reactor Power Control
Although there have been some severe nuclear accidents such as Three Mile Island (USA), Chernobyl (Ukraine) and Fukushima (Japan), nuclear fission energy is still a source of clean energy that can substitute fossil fuels in a centralized way and in a great amount with commercial availability and economic competitiveness. Since the pressurized water reactor (PWR) is the most widely used nuclear ...
full textPressurized hydrogenotrophic denitrification reactor for small water systems.
The implementation of hydrogenotrophic denitrification is limited due to safety concerns, poor H2 utilization and low solubility of H2 gas with the resulting low transfer rate. The current paper presents the main research work conducted on a pressurized hydrogenotrophic reactor for denitrification that was recently developed. The reactor is based on a new concept suggesting that a gas-liquid eq...
full textDesign and Implementation of a Fuzzy Logic Controller for the Pressurized Water Power Reactor Control
ABSTRACT The pressurized water reactor type power plant has a sophisticated automatic control systems. On the primary side, The Control rod system and the Soluble boron control the core neutron flux. On the secondary side, output steam is controlled by the turbine control valve and steam dump system. During the automatic control mode, the two sides work in a synchronized way so that transition ...
full textMy Resources
Journal title
volume 3 issue 1
pages 63- 79
publication date 1990-05-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023