Asymptotic Analysis of Binary Gas Mixture Separation by Nanometric Tubular Ceramic Membranes: Cocurrent and Countercurrent Flow Patterns
Authors: not saved
Abstract:
Analytical gas-permeation models for predicting the separation process across membranes (exit compositions and area requirement) constitutes an important and necessary step in understanding the overall performance of membrane modules. But, the exact (numerical) solution methods suffer from the complexity of the solution. Therefore, solutions of nonlinear ordinary differential equations that govern the performance of the membrane modules for gas separations by approximate and asymptotic methods are useful in the design and comparison of processes. In this work, the asymptotic methods were applied for predicting the performance of nanometric tubular ceramic membranes in the separation of binary gas mixtures with cocurrent and countercurrent flow patterns. Also, the exact (numerical) solutions of the governing equations using the fourth order Rung-Kutta technique were proposed. The comparison of the results showed a good agreement between the exact solution and asymptotic analysis methods over the whole range of selectivities (). Because, the asymptotic curves into the former () and latter () boundaries had a suitable overlap with each other to cover the whole range of selectivities. The accuracy of this method was verified by a comparison of the predicted results with different literature experimental data and mathematical models. This result suggests the use of the asymptotic analysis method to provide excellent shortcut, preliminary design information.
similar resources
Gas transport and separation with ceramic membranes. Part II. Synthesis and separation properties of microporous membranes
Non-supported microporous silica (amorphous) and titania thin films were made by the polymeric gel route. The titania system consisted of particles smaller than 5 nm. Reproducible modification of supported y-alumina films with silica demands a strict control of every modification step. Silica films of 3060 nm thickness on top of and presumably partly inside the y-alumina film were realised. The...
full textGas Separation by Supported Ionic Liquid Membranes
The use of ionic liquids (ILs) for gas separation processes recently has attracted much attention due to high solubilities of different gaseous species in ionic liquids [1]. The preparation of supported ionic liquid membranes (SILMs) is also reported for selective separation of different organic or gaseous compounds. Research activities have amongst others focused on CO2 separation from gas str...
full textPlasticization of gas separation membranes*
For the investigation of the plasticizing effect of carbon dioxide on polymers used for gas separation membranes new experimental methods have been developed that measure the sorption kinetics as well as the dilation kinetics. Comparing dilation and sorption kinetics at low and elevated pressures gives information about different types of swelling behaviour depending on the pressure level. Volu...
full textDense Ceramic Membranes for Hydrogen Separation
In the 1980s and 1990s, the development of oxygen ion conductors for solid electrolytes, as well as mixed oxygen–electron conductors as electrodes for solid oxide fuel cells, brought scientists to envision a possibility of mixed-conducting oxygenpermeable ceramic membranes. Today this field is well established, and ceramic membranes are close to implementation in processes for oxygen extraction...
full textDense Ceramic Membranes for Hydrogen Separation
Novel cermet (i.e., ceramic-metal composite) membranes have been developed for separating hydrogen from product streams that are generated during coal gasification, methane partial oxidation, and watergas shift reactions. The hydrogen permeation rate in the temperature range of 600-900°C has been measured for three classes (ANL-1, -2, and -3) of cermet membranes. ANL-3 membranes provided the hi...
full textMy Resources
Journal title
volume 3 issue 3
pages 3- 16
publication date 2006-07-01
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023