Absorbed dose of sensitive organs in maxillofacial region by different radiographic techniques: Panoramic, Waters, Caldwell and cone-beam computed tomography
Authors
Abstract:
BACKGROUND AND AIM: Due to increasing use of X-rays in diagnosis and treatment of diseases, this study aimed to measure and compares the absorbed dose in a number of sensitive organs of head and neck in different radiographic techniques.METHODS: Thermoluminescence dosimeter (TLD) and a male equivalent RANDO phantom were used to measure the absorbed dose in organs. The dosimeters were set in certain sites of phantom related to eye, parotid, thyroid gland, occipital area and temporomandibular joint (TMJ). Panoramic and Caldwell techniques with two different exposure conditions as well as Waters technique with three different exposure conditions were performed. Cone-beam computed tomography (CBCT) was applied in low and normal resolutions with different field of view (FOV), and the mean absorbed dose was calculated and compared by the dosimeters related to each of the organs.RESULTS: The panoramic imaging technique revealed the lowest dose for the eyes, but interestingly higher doses for the parotid gland and the occipital area. In total, Waters and Caldwell imaging techniques indicated that the occipital area and the parotid gland absorbed a higher dose than other organs. In the majority of CBCT scans the parotid region received the highest dose. However, during sinus CBCT (both in low-dose and high-dose modes), the TMJ and eye areas absorbed the highest dose. Investigation of the use of thyroid shield on the absorbed dose in this organ in CBCT showed an average 22% reduction in dose.CONCLUSION: In total, panoramic, Waters and Caldwell imaging techniques indicated that the occipital area and the parotid gland absorbed a higher dose than other organs. In the majority of CBCT scans, the parotid region received the highest dose.
similar resources
Dosimetry of Critical Organs in Maxillofacial Imaging with Cone-beam Computed Tomography
Background: While the benefits of cone-beam computed tomography (CBCT) are well known in maxillofacial imaging, the use of this modality is not risk-free.Objective: The aim of this study was to evaluate the exposure doses received by patients during maxillofacial imaging with CBCT.Methods: Entrance surface dose (ESD) was measured by using thermoluminescent dosimeters (TLDs) attached to the eyes...
full textdetection of foreign bodies by spiral computed tomography and cone beam computed tomography in maxillofacial regions
background and aims. the imaging techniques commonly used for foreign body detection include plain radiography, xeroradiography, computed tomography (ct) scans, magnetic resonance imaging (mri) and ultrasonography. the aim of the present study was to compare cone-beam computed tomography (cbct) with conventional ct scan in determination of the exact location of a foreign body in the maxillofaci...
full textDetection of Foreign Bodies by Spiral Computed Tomography and Cone Beam Computed Tomography in Maxillofacial Regions
Background and aims. The imaging techniques commonly used for foreign body detection include plain radiography, xeroradiography, computed tomography (CT) scans, magnetic resonance imaging (MRI) and ultrasonography. The aim of the present study was to compare cone-beam computed tomography (CBCT) with conventional CT scan in determination of the exact location of a foreign body in the maxillofaci...
full textForeign Body in Nasal Cavity: Panoramic and Cone-Beam Computed Tomography (CBCT) Findings
Introduction: Panoramic view as a routine dental radiograph has an important role in diagnosis of other facial abnormalities accompanied with dento- alveolar structures. In this case presentation, we discuss this subject and also the efficacy of cone-beam computed tomography in localization of foreign body in complex anatomy of nasal cavity.
full textAssessment of Accessory Mental Foramen by Cone-Beam Computed Tomography
Introduction: Any foramen in the buccal surface of mandibular body that transfers mental nerve and vessels except mental foramen, is called Accessory Mental Foramen (AMF). The objective of this study was the determination of the AMF using cone-beam computed tomography (CBCT). Materials and Methods: this descriptive study was done on 180 CBCT projections which were selected by convenience samp...
full textEvaluation of neurovascular anatomical variations in maxillary anterior region in cone beam computed tomography images
Introduction: Incisive foramen in the maxilla is the oral terminus of the nasopalatine canal. This region is important in implantology, Therefore, the aim of this study was to investigate the neurovascular anatomical variations in the maxillary anterior region, observed on cone beam computed tomography (CBCT) images. Materials &Methods: In this cross-sectional study, maxillary CBCT ima...
full textMy Resources
Journal title
volume 6 issue 3
pages 121- 129
publication date 2017-07-05
By following a journal you will be notified via email when a new issue of this journal is published.
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023