a w-band simultaneously matched power and noise low noise amplifier using cmos 0.13µm
Authors
abstract
a complete procedure for the design of w-band low noise amplifier in mmic technology is presented. the design is based on a simultaneously power and noise matched technique. for implementing the method, scalable bilateral transistor model parameters should be first extracted. the model is also used for transmission line utilized in the amplifier circuit. in the presented method, input/output matching networks and transistor gate width have been optimized for simultaneous maximum gain and minimum noise figure. it is easily shown that due to the low gain property of amplifier at high frequency, it is unconditionally stable; so, the common source topology has superior performance compared to other topologies. in addition, better noise figure, lower size and higher gain with the same power consumption can be achieved compared with those of the cascode topology. the simulation results show a gain of better than 18db and noise figure of 7.4db at 94ghz while input/output return losses are better than 20db
similar resources
A W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
full textA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13μm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
full textLow Power Low Noise CMOS Chopper Amplifier
AbstractChopping is a proficient way to reduce the low frequency offset and 1/f noise in amplifiers. In this paper, a low power low noise CMOS chopper amplifier is presented. It is composed of a two stage amplifier. The first stage’s high output impedance and the equivalent Miller capacitance of the second stage constitute together a low pass filter, which reduces the power consumption. The cir...
full textA Concurrent Dual-Band Low Noise Amplifier for GNSS Receivers
In this paper, a new design of concurrent dual-band Low Noise Amplifier (LNA) for multi-band single-channel Global Navigation Satellite System (GNSS) receivers is proposed. This new structure is able to operate concurrently at frequency of 1.2 and 1.57 GHz. Parallel and series resonance parts are employed in the input matching in order to achieve concurrent performance. With respect to used pse...
full textLow Noise Low Power Transimpedance Amplifier in 0.18μm Cmos Technology
Low noise and low Power transimpedance amplifiers (TIA) are essential modules for optical sensor based systems. But low power and low noise TIAs are still a challenge for the scientists despite of rapid advances in complementary metal oxide semiconductor (CMOS) technology. This paper proposes a three-stage nested miller compensated (NMC) based design of low noise low power transimpedance amplif...
full textMy Resources
Save resource for easier access later
Journal title:
journal of computer and roboticsجلد ۷، شماره ۲، صفحات ۹-۱۴
Hosted on Doprax cloud platform doprax.com
copyright © 2015-2023