Control Method of the DFIG Connected to a DC Link through a Diode Bridge
نویسندگان
چکیده
This paper presents a control method for the Doubly-fed Induction Generator connected to a dc link through a diode bridge on the stator. In this system, the rotor is fed, at the slip frequency, by a PWM electronic converter and the stator is directly connected to the dc link using a simple diode bridge. The cost of power electronics is reduced in this system when compared with the classic DFIG machine because the system uses less one PWM inverter and additionally it uses a diode bridge. The application in mind is for microgrids. Microgrids need several elements that should work together. The usual way to connect these elements is to use power electronic devices in a common dc link. This paper presents a new form for the DFIG for this application and presents a control system for the inner control loop. Simulation and experimental results show that the system can work acceptably using a stator frequency near the rated frequency of the machine.
منابع مشابه
Low Voltage Ride Through Enhancement Based on Improved Direct Power Control of DFIG under Unbalanced and Harmonically Distorted Grid Voltage
In the conventional structure of the wind turbines along with the doubly-fed induction generator (DFIG), the stator is directly connected to the power grid. Therefore, voltage changes in the grid result in severe transient conditions in the stator and rotor. In cases where the changes are severe, the generator will be disconnected from the grid and consequently the grid stability will be attenu...
متن کاملControl System Design and Fault-Ride-through Performance Analysis of Grid-Connected Microturbine Generation System
In recent years, microturbines as one the distributed generation sources have widly used. This paper investigates the control structure of the microturbine and analyzes its performance in grid-connected mode. In this way, first, the mechanical model of the microturbine is presented. Then, the electrical structure of the microturbine, consisting of permanent magnet synchronous generator (PMSG) ...
متن کاملDesign and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملEnhancement of Fault Ride through Capability of a Wind Driven Dfig Connected to the Grid
Enhancement of fault ride-through (FRT) capability and subsequent improvement of rotor speed stability of wind farms equipped with doubly fed induction generator (DFIG) is the objective of this paper. The objective is achieved by employing a novel FRT scheme with suitable control strategy. The proposed FRT scheme, which is connected between the rotor circuit and dc link capacitor in parallel wi...
متن کاملبهبود قابلیت گذر از خطای منابع تولید پراکنده مبتنی بر اینورتر با استفاده از محدود کنندهی جریان خطا
By increasing the penetration level of the inverter-based distributed generations (IBDGs) in power system, their fault ride through capability has become one of the essential issues of the new grid codes. This paper proposes a novel method to limit inverter fault currents which are used in DGs. To achieve FRT, interface-inverter operates as a controlled voltage source during normal operation as...
متن کامل