Some traffic features at freeway bottlenecks
نویسندگان
چکیده
Observations from two freeway bottlenecks in and near Toronto, Canada indicate that the average rate vehicles discharge from a queue can be 10% lower than the flow measured prior to the queue’s formation. Absent any influences from downstream, the queue discharge flows exhibited nearly stationary patterns that alternated between higher and lower rates. These alternating flow patterns were especially evident at one of the two sites, although the feature occurred at both sites during periods that immediately followed the onset of upstream queueing; i.e. a queue’s formation was always accompanied by a relatively low dis charge rate followed later by a temporary surge in the discharge flow. When plotted cumulatively over time, however, the counts of discharging vehicles generally did not deviate by more than about 50 vehicles from a trend line of constant slope. Thus, the discharge flows are described as being ‘nearly’ constant; i.e. they varied (slightly) about a fixed rate. At each site, this average discharge rate exhibited little deviation from day to day. The present findings came by visually comparing transformed curves of cumulative vehicle arrival number vs time and cumulative occupancy vs time measured at neighboring loop detectors. This treatment of the data provided clear presentations of some important traffic features and this facili tated a detailed study of bottleneck flows. © 1998 Published by Elsevier Science Ltd. All rights reserved.
منابع مشابه
Comparing a Bottleneck Identification Tool with the Congested Traffic Pattern Recognition System Asda/foto Using Archived Freeway Data from Portland, Oregon
Bottlenecks are key features of any freeway system and represent the emerging location for recurrent and non-recurrent traffic congestion. In Oregon, a freeway data archive known as PORTAL records volume, occupancy, and speed measurements from over 600 freeway locations every 20 seconds. This archive has enabled development of online freeway performance and reliability analysis tools. This pape...
متن کاملSome Properties of Flows at Freeway Bottlenecks
The capacity of a freeway segment should be measured only when it is an active bottleneck. The properties of flows at active freeway bottlenecks have a bearing on both the definition of capacity and the procedure of capacity analysis. Past studies have examined the flow features at bottlenecks on several freeways in Toronto, Canada, and San Diego, California. This study examined 27 active bottl...
متن کاملQueuing and Statistical Analysis of Freeway Bottleneck Formation
A modified approach to treat traffic flow parameters (flow, density, and speed) has been introduced in this paper. A queuing analysis has been conducted on traffic flow data on Interstate 94 in the Minneapolis–St. Paul metro area. A methodology has been developed to calibrate loop detector count data. Corrected flow data has been subjected to analysis using queuing analysis to compute densities...
متن کاملIntegrating an Automated Bottleneck Detection Tool into an Online Freeway Data Archive
Bottlenecks are key features of any freeway system. Their impacts are of increasing importance as congestion worsens in major urban areas. In the U.S., the FHWA has been working to identify and monitor key bottlenecks in each state. In Oregon, a freeway data archive known as PORTAL records count, occupancy, and speed measurements from over 600 freeway locations. This archive has enabled develop...
متن کاملModeling Traffic at Sags
Freeway capacity decreases at sags due to local changes in car-following behavior. Consequently, sags are often bottlenecks in freeway networks. This article presents a microscopic traffic model that reproduces traffic flow dynamics at sags. The traffic model includes a new car-following model that takes into account the influence of freeway gradient on vehicle acceleration. The face-validity o...
متن کامل