A New Single Wire Readcut System-for Spark Chambers*
نویسندگان
چکیده
A new, conceptually very simple, single wire readout system for spark chambers in strong magnetic fields is described. (Submitted to Nucl. Instr. and Methods. ) *Work supported in part by the U. S. Atomic Energy Commission. Prepared under Contracts AT(04-3)-5 15 and AT(ll-l)-68 for the San Francisco Operations Office, U. S. Atomic Energy Commission.
منابع مشابه
Wire Arrays Vs Vidicons: a Comparison of Large Wire Arrays with Optical Spark Chambers Using Vidicon Readout
Digitized spark-chamber systems using wire arrays are being used for increas ingly complex types of events; their chief virtue is the provision of "on-line II informa tion on the progre ss of the experiment, which we inte rpret as rapid enough to aIIow the results obtained to influence the future course of the experiment. Such on-line operation can also be obtained by several other methods fo...
متن کاملNew Developments in the Magnetostrictive Readout System at Slac*
The present paper describes the work done at SLAC for the magnetostrictive wire spark chambers of SPEAR, LASS and the two-meter streamer chamber. All three are CAMAC systems based on the use of a time digitizer module with different interfacing techniques into three different computers (Sigma 5, PDP-9, PDP-11). Of particular interest is a display controller module that permits wide selection of...
متن کاملIntelligent Knowledge Based System Approach for Optimization of Design and Manufacturing Process for Wire-Electrical Discharge Machining
Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...
متن کاملIntelligent Knowledge Based System Approach for Optimization of Design and Manufacturing Process for Wire-Electrical Discharge Machining
Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...
متن کاملROBUST FUZZY CONTROL DESIGN USING GENETIC ALGORITHM OPTIMIZATION APPROACH: CASE STUDY OF SPARK IGNITION ENGINE TORQUE CONTROL
In the case of widely-uncertain non-linear system control design, it was very difficult to design a single controller to overcome control design specifications in all of its dynamical characteristics uncertainties. To resolve these problems, a new design method of robust fuzzy control proposed. The solution offered was by creating multiple soft-switching with Takagi-Sugeno fuzzy model for optim...
متن کامل