Forward flight of birds revisited. Part 2: short-term dynamic stability and trim
نویسنده
چکیده
Thrust generation by flapping is accompanied by alternating pitching moment. On the down-stroke, it pitches the bird down when the wings are above its centre of gravity and up when they are below; on the up-stroke, the directions reverse. Because the thrust depends not only on the flapping characteristics but also on the angle of attack of the bird's body, interaction between the flapping and body motions may incite a resonance that is similar to the one that causes the swinging of a swing. In fact, it is shown that the equation governing the motion of the bird's body in flapping flight resembles the equation governing the motion of a pendulum with periodically changing length. Large flapping amplitude, low flapping frequency, and excessive tilt of the flapping plane may incite the resonance; coordinated fore-aft motion, that uses the lift to cancel out the moment generated by the thrust, suppresses it. It is probably incited by the tumbler pigeon in its remarkable display of aerobatics. The fore-aft motion that cancels the pitching moment makes the wing tip draw a figure of eight relative to the bird's body when the wings are un-swept, and a ring when the wings are swept back and fold during the upstroke.
منابع مشابه
Trim and Maneuverability Analysis Using a New Constrained PSO Approach of a UAV
Performance characteristic of an Unmanned Air Vehicle (UAV) is investigated using a newly developed heuristic approach. Almost all flight phases of any air vehicle can be categorized into trim and maneuvering flights. In this paper, a new envelope called trim-ability envelope, is introduced and sketched within the conventional flight envelope for a small UAV. Optimal maneuverability of the inte...
متن کاملForward flight of birds revisited. Part 1: aerodynamics and performance
This paper is the first part of the two-part exposition, addressing performance and dynamic stability of birds. The aerodynamic model underlying the entire study is presented in this part. It exploits the simplicity of the lifting line approximation to furnish the forces and moments acting on a single wing in closed analytical forms. The accuracy of the model is corroborated by comparison with ...
متن کاملConsidering chain to chain competition in forward and reverse logistics of a dynamic and integrated supply chain network design problem
In this paper, a bi-objective model is presented for dynamic and integrated network design of a new entrant competitive closed-loop supply chain. To consider dynamism and integration in the network design problem, multiple long-term periods are regarded during planning horizon, so that each long-term period includes several short-term periods. Furthermore, a chain to chain competition between t...
متن کاملIn-Trim Flight Investigations of a Conceptual Fluidic Thrust-Vectored Unmanned Tail-Sitter Aircraft
The feasibility of using a stand alone Fluidic Thrust-Vectoring (FTV) system for the purpose of longitudinal trim of an unmanned aerial vehicle is the focus of the research presented in this paper. Since the fluidic thrust vectoring requires high pressure secondary air to deflect the engine exhaust gases, this research also provides an analytical toolset for preliminary sizing of a suitable sec...
متن کاملFlight Dynamics of Highly Flexible Flying Wings
The paper presents a theory for flight dynamic analysis of highly flexible flying wing configurations. The analysis takes into account large aircraft motion coupled with geometrically nonlinear structural deformation subject only to a restriction to small strain. A large motion aerodynamic loads model is integrated into the analysis. The analysis can be used for complete aircraft analysis inclu...
متن کامل