Stability of up-milling and down-milling, part 2: experimental verification
نویسندگان
چکیده
The stability of interrupted cutting in a single degree of freedom milling process was studied experimentally. An instrumented flexure was used to provide a flexible workpiece with a natural frequency comparable to the tooth pass frequency, mimicking high speed milling dynamics. The displacement of the system was sampled continuously and periodically once per cutter revolution. These data samples were used to asses the stability of the system. Results confirm the theoretical predictions obtained in Part 1. 2002 Elsevier Science Ltd. All rights reserved.
منابع مشابه
Stability of up-milling and down-milling, part 1: alternative analytical methods
The dynamic stability of the milling process is investigated through a single degree of freedom mechanical model. Two alternative analytical methods are introduced, both based on finite dimensional discrete map representations of the governing time periodic delay-differential equation. Stability charts and chatter frequencies are determined for partial immersion upand down-milling, and for full...
متن کاملExperimental investigation of the gyroscopic and rotary inertia effects on the chatter boundary in a milling process
Experimental examination of the gyroscopic and rotary inertia effects on the chatter boundary in a milling operation is the chief aim of this article. The equations of motion of the tool vibration are derived based on Timoshenko beam theory and Hamilton principle by considering gyroscopic moment, rotary inertia, velocity-dependent process damping and radial immersion effect. For a range of dept...
متن کاملComparing up and Down Milling Modes of End-Milling Using Temporal Finite Element Analysis
Two types of end milling at partial radial immersion are distinguished in this work, namely; up and down end-milling. They are theoretically given comparative study for a three tooth end miller operating at 0.5, 0.75 and 0.8 radial immersions. 0.5 and 0.8 radial immersion conditions are chosen so that analysis covers situations in which repeat and continuous tool engagements occur while 0.75 ra...
متن کاملA Comparative Study of the Synthesis and Thermal Stability of Nanostrucrured Al and Al-Mg Powders Fabricated by Mechanical Alloying Technique
Nanostructured Al and Al-Mg (Mg 30 wt. %) powders with the mean crystallite sizes of 42 and 11 nm were prepared through the solid state ball milling technique. The milling process was performed for various times up to 12 h in argon atmosphere and the synthesized powders were in detail characterized by different techniques. The effect of milling time and Mg addition on the size, morphology, chem...
متن کاملStable Milling of Thin-Walled Parts with Variable Dynamics
The milling of thin-walled parts can become a seriously complex problem. In this work, the problem of the variable dynamics of a test part has been solved through the calculation of 3D stability lobes which add a third dimension with the tool position along the part, to the traditional depth of cut-spindle speed pair. First, the dynamics of a test part in several machining steps have been calcu...
متن کامل