Matching the power density and potentials of biological systems: A 3.1-nW, 130-mV, 0.023-mm3 pulsed 33-GHz radio transmitter in 32-nm SOI CMOS

نویسندگان

  • Jaebin Choi
  • Eyal Aklimi
  • Jared Roseman
  • David Tsai
  • Harish Krishnaswamy
  • Kenneth L. Shepard
چکیده

A 3.1 nJ/bit pulsed millimeter-wave transmitter, 300μm by 300μm by 250μm in size, designed in 32-nm SOI CMOS, operates on an electric potential of 130mV and 3.1nW of dc power. These achieved power levels and potentials are comparable to those present across cellular and intracellular membranes. Far-field data transmission at 33 GHz is achieved by supply-switching an LC-oscillator with a duty cycle of 10. The time interval between pulses carries information on the amount of power harvested by the radio, supporting a data rate of ~1bps. The inductor of the oscillator also acts as an electrically small (~λ/30) on-chip antenna, enabling the extremely small form factor. Index Terms — Implantable biological devices, low-power electronics, microwave antennas, millimeter wave communication, switched capacitor circuits.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers

A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...

متن کامل

A Power-efficient Process Selection, Gain Optimization, and Noise Canceling Technique for a 130-nm Microwave Amplifier Jes Journal of Electrical Systems

Employing 130-nm IBM CMOS model parameters, the design of a power-efficient single-stage microwave amplifier is presented in this paper. An optimization technique for the amplifier forward gain is proposed through careful selection of process elements without compromising the architecture’s high degree of isolation and resistance to reflection-loss. A novel mechanism to match port-impedances of...

متن کامل

Class-E Power Amplifiers for Pulsed Transmitters

Nowadays the main driving parameters for the radio transmitter research are: energy efficiency, frequency re-configurability and integration. Pulsed transmitter architectures have attracted large interest in the recent years due to their potential to meet these demands. In pulsed transmitters, a highly efficient switch mode power amplifier (SMPA) is used in conjunction with a pulse modulator to...

متن کامل

Cmos Power Device Modeling and Amplifier Circuits By

A power amplifier (PA) is a key part of the RF front-end in transmitters for a local broadband network. Today, commercial PAs are made of III-V HEMT and HBT technology with excellent results. An integrated system-on-chip power amplifier circuit using CMOS technology for cost-effective and spectrum-efficient high-speed wireless communication presents major challenges because power amplifiers hav...

متن کامل

Design and modeling of mm - wave integrated transformers in CMOS and BiCMOS technologies

Millimeter-wave wireless communication systems have considerably gained in importance in recent years. Important applications as 60-GHz WLANs and WPANs, 80-GHz automotive radar, and 94 GHz imaging have emerged, requiring significant effort on the design of transceiver's silicon-based integrated circuits. In this context, integrated transformers are of a particular interest. They may perform, am...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2014