Evaluation of soluble benzene migration in the Uinta Basin

Field sampling and mathematical modeling are used to study the long-distance transport and attenuation of petroleum-derived benzene in the Uinta Basin, Utah. Benzene concentration was measured from oil and oil field formation waters of the Altamont-Bluebell and Pariette Bench oil fields in the basin. It was also measured from springs located in the regional groundwater discharge areas, hydraulically down-gradient from the oil fields sampled. The average benzene concentration in oils and co-produced waters is 1946 and 4.9 ppm at the AltamontBluebell field and 1533 and 0.6 ppm at the Pariette Bench field, respectively. Benzene concentration is below the detection limit in all springs sampled. Mathematical models are constructed along a north south trending transect across the basin through both fields. The models represent groundwater flow, heat transfer and advective/ dispersive benzene transport in the basin, as well as benzene diffusion within the oil reservoirs. The coupled groundwater flow and heat transfer model is calibrated using available thermal and hydrologic data. We were able to reproduce the observed excess fluid pressure within the lower Green River Formation and the observed convective temperature anomalies across the northern basin. Using the computed best-fit flow and temperature, the coupled transport model simulates water washing of benzene from the oil reservoirs. Without the effect of benzene attenuation, dissolved benzene reaches the regional groundwater discharge areas in measurable concentration (>0.01 ppm); with attenuation, benzene concentration diminishes to below the detection limit within 1 4 km from the reservoirs. Attenuation also controls the amount of water washing over time. In general, models that represent benzene attenuation in the basin produce results more consistent with field observations.