Durability of FRP rods for concrete structures

نویسندگان

  • Francesco Micelli
  • Antonio Nanni
چکیده

Over the last two decades fiber-reinforced polymer (FRP) rods have emerged as one of the most promising and affordable solutions to the corrosion problems of steel reinforcement in structural concrete. The application of FRP rods in new or damaged structures requires the development of design equations that must take into account the mechanical properties and the durability properties of FRP products. Concerns still remain about the structural behavior of FRP materials under severe environmental and load conditions for longtime exposures. In the case of glass FRP rods, it is the high pH of the pore water solution created during the hydration of the concrete that may cause the chemical attack of the fibers. In this study, an effort was made to develop an experimental protocol to study the effects of accelerated aging on FRP rods. The physico-mechanical properties of five types of carbon and glass FRP rods were investigated. FRP specimens were subjected to alkaline simulated concrete pore solution and environmental agents including freeze-thaw, high relative humidity, high temperature and ultraviolet (UV) radiations. Mechanical and physical tests were used to measure the retained properties and to observe the causes of damage and strength reduction. The experimental data showed that resin properties may strongly influence the durability of FRP reinforcement, environmental combined cycles did not take to significant damage of conditioned rod-specimens, GFRP rods are sensitive to alkaline attack when resin does not provide adequate protection to fibers. 2004 Elsevier Ltd. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Issues Related to Durability of Frp Reinforcement for Rc Structures Exposed to Accelerated Ageing

Corrosion of steel reinforcement in an aggressive environment constitutes a serious problem for many reinforced concrete (RC) structures. Fiber-reinforced polymers (FRP) rebars represent a potential solution to this situation. Even if FRP reinforcement shows a good resistance to electro-chemical corrosion, long-term behavior must be investigated and proven. The mechanical properties of FRP rods...

متن کامل

Durability of the Bonding Performance of Frp-concrete Interface Externally Bonded with Frp Composite Sheet

The strengthening of concrete structures externally bonded with fiber reinforced polymer (FRP) sheet is increasingly being used for repair and rehabilitation of existing structures. This paper provides information in the area of long-term durability of FRP-concrete interface externally bonded with FRP composite sheet. It mainly discusses and summarizes the influence of harsh environmental expos...

متن کامل

Influence of Fiber Surface Treatment on the Flexural Behavior of Frp Strengthened Mortar

There is a growing need for the rehabilitation, repair, and upgrading of concrete structures such as bridges and buildings. The repair or rehabilitation of reinforced concrete structures often offers a lower cost alternative to rebuilding, and it is traditionally achieved by bonding steel plates to the tensile face of a reinforced concrete member. The shear strength can be enhanced with plates ...

متن کامل

Strengthening of Rc Structures with near Surface Mounted Frp Rods

Disclaimer The contents of this report reflect the views of the author(s), who are responsible for the facts and the accuracy of information presented herein. This document i s disseminated under the sponsorship of the Center for Infrastructure Engineering Studies (CIES), University of Missouri-Rolla, in the interest of information exchange. CIES assumes no liability for the contents or use the...

متن کامل

A Sample of International Production FRP Reinforcement for Concrete Structures

fi ber reinforced plastic (FRP) re. nforcement is one of the most promising new developments for concrete structures. FRP reinforcing elements provide lighter, easier to assemble, and more durable structures that are free of the deterioration caused by corrosion of steel. FRPs consist of synthetic or organic highstrength fibers, most of which are impregnated with a resin matrix. They are availa...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004