Integration of Interfaces and Stabilization System in the Design of a Drift Tube Linac
نویسندگان
چکیده
Making an accurate Radio Frequency, RF, design of any accelerating structure is fundamental to ensure that electromagnetic and beam dynamics requirements will be achieved. This is essential for the most complicated accelerating structures like the Drift Tube Linac, DTL; in this case a meticulous design facilitates the RF commissioning too. In this paper the influence of the interfaces and of the field stabilization system on the RF design is analyzed and an advanced design methodology to mitigate field degradation is presented.
منابع مشابه
Analyzing the Behavior of Hybrid Steel System of Tube in Tube with Bracing and Belt Truss
Nowadays, due to the escalation in construction of high-rise structures, the need for selecting a proper resistant structural system against earthquake and wind has increased significantly. These systems should show an optimized use of materials and should be presented as a hard and efficient structure. A good example of a high efficient system in high-rise buildings can be indicated is, the tu...
متن کاملMULTI-OBJECTIVE SEMI-ACTIVE BASE ISOLATION SYSTEM
Semi-active base isolation system has been proposed mainly to mitigate the base drift of isolated structures while in most cases, its application causes the maximum acceleration of superstructure to be increased. In this paper, designing optimal semi-active base isolation system composed of linear base isolation system with low damping and magneto-rheological (MR) damper has been studied for co...
متن کاملDesign of a Carbon Injector for a Medical Accelerator Complex
A design study of a 7 MeV/u C injector LINAC for a synchrotron for light-ion tumour therapy is presented. The injector consists of a 14.5 GHz ECR ion source, a LEBT line, a 216 MHz RFQ structure of 1.2 m length for acceleration from 6 keV/u to 300 keV/u and a subsequent 216 MHz IH drift tube LINAC of 4.0 m length for acceleration to 7 MeV/u. The IH structure consists of four drift tube sections...
متن کاملPerformance-Based Plastic Design of Moment Frame-Steel Plate Shear Wall as a Dual System
Steel Plate Shear Wall (SPSW) is an emerging seismic load-resistant system that, compared to other systems, enjoys the advantages of stable ductile behavior, fewer detailing requirements, rapid constructability, and economy. American seismic provisions decree that a SPSW should be designed as a moment frame with a web infill plate. Specifically, in case of buildings taller than 160 ft, it decre...
متن کاملطراحی و شبیهسازی ستون شتابدهنده دوترونی الکترواستاتیکی 2MV
In this paper design and simulation of an optimized accelerator tube is presented for the production of light charged particles up to energy of 2 MeV. Geometry of the accelerator tube electrodes was simulated based on the Van De Graaff accelerator tubes of Atomic Energy Organization by SIMION 7.0, Virtual Device and SIMION Toolkit codes. In accelerator tube, the extracted ion beam from the ion ...
متن کامل