Design of Low Power Cmos Low Noise Amplifier Using Current Reuse Method-a Review
نویسندگان
چکیده
LNA is one of the most important building blocks in the front end of the wireless communication systems. Amplification of weak signal and attenuation in noise level is a key role of LNA. In recent years valuable research is done on CMOS LNA design in on improvement of low power consumption, low noise figure, high gain, smaller space and low supply voltage. This paper illustrates a review work regarding the low power LNA design. The paper describes some fundamentals of LNA, designing method for low power LNA and design steps. This paper will be beneficial for primary stage of CMOS LNA design with low power consumption.
منابع مشابه
A W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملDesign of a New Low-Power 2.4 GHz CMOS LNA
A 2.4-GHz single-stage CMOS low noise amplifier (LNA) structure with ultra low power consumption is proposed. A current reuse technique is used to decrease power dissipation with increasing amplifier transconductance for the LNA. Thus, the same amplifier transconductance for the LNA will be achieved at decreased power dissipation. Also, due to the use of an inverter-type amplifier which has a s...
متن کاملA 0.13μm CMOS Low-Noise Amplifier Using Resistive Feedback Current Reuse Technique for 3.1-10.6 GHz Ultra-Wideband Receivers
Department of Physics and Electronics, University of Science-VNU Hochiminh City, Vietnam; Faculty of Electrical and Electronics Engineering, University of Technology, VNU Hochiminh City, Vietnam; Department of Electrical and Computer Engineering, University of Saskatchewan, Saskatoon, Canada Corresponding Author: Nhan Nguyen ______________________________________________________________________...
متن کاملA Novel Resistive Capacitive Feedback Trans-impedance Amplifier Optimization Using IPSO Algorithm
A novel low noise trans-impedance amplifier is proposed using low cost 0.18 µm CMOS technology. A resistive-capacitive feedback is used to extend the bandwidth of the amplifier. As the structure is inductor less, it is suitable for low cost integrated optical interconnects. In this paper Improved Particle Swarm Optimization have applied to determine optimal trans-resistance and noise of propose...
متن کامل