Assessing the impact of model spin-up on surface water-groundwater interactions using an integrated hydrologic model
نویسندگان
چکیده
Integrated land surface-groundwater models are valuable tools in simulating the terrestrial hydrologic cycle as a continuous system and exploring the extent of land surface-subsurface interactions from catchment to regional scales. However, the fidelity of model simulations is impacted not only by the vegetation and subsurface parameterizations, but also by the antecedent condition of model state variables, such as the initial soil moisture, depth to groundwater, and ground temperature. In land surface modeling, a given model is often run repeatedly over a single year of forcing data until it reaches an equilibrium state: the point at which there is minimal artificial drift in the model state or prognostic variables (most often the soil moisture). For more complex coupled and integrated systems, where there is an increased computational cost of simulation and the number of variables sensitive to initialization is greater than in traditional uncoupled land surface modeling schemes, the challenge is to minimize the impact of initialization while using the smallest spin-up time possible. In this study, multicriteria analysis was performed to assess the spinup behavior of the ParFlow.CLM integrated groundwater-surface water-land surface model over a 208 km subcatchment of the Ringkobing Fjord catchment in Denmark. Various measures of spin-up performance were computed for model state variables such as the soil moisture and groundwater storage, as well as for diagnostic variables such as the latent and sensible heat fluxes. The impacts of initial conditions on surface water-groundwater interactions were then explored. Our analysis illustrates that the determination of an equilibrium state depends strongly on the variable and performance measure used. Choosing an improper initialization of the model can generate simulations that lead to a misinterpretation of land surface-subsurface feedback processes and result in large biases in simulated discharge. Estimated spin-up time from a series of spin-up functions revealed that 20 (or 21) years of simulation were sufficient for the catchment to equilibrate according to at least one criterion at the 0.1% (0.01%) threshold level. Amongst a range of convergence metrics examined, percentage changes in monthly values of groundwater and unsaturated zone storages produced a slow system convergence to equilibrium, whereas criteria based on ground temperature allowed a more rapid spin-up. Slow convergence of unsaturated and saturated zone storages is a result of the dynamic adjustment of the water table in response to a physically arbitrary or inconsistent initialization of a spatially uniform water table. Achieving equilibrium in subsurface storage ensured equilibrium across a spectrum of other variables, hence providing a good measure of system-wide equilibrium. Overall, results highlight the importance of correctly identifying the key variable affecting model equilibrium and also the need to use a multicriteria approach to achieve a rapid and stable model spin-up.
منابع مشابه
Technical Note: Reducing the spin-up time of integrated surface water–groundwater models
One of the main challenges in the application of coupled or integrated hydrologic models is specifying a catchment’s initial conditions in terms of soil moisture and depth-to-water table (DTWT) distributions. One approach to reducing uncertainty in model initialization is to run the model recursively using either a single year or multiple years of forcing data until the system equilibrates with...
متن کاملHydrologic responses of watershed assessment to land cover and climate change using soil and water assessment tool model
Predicting the impact of land cover and climate change on hydrologic responses using modeling tools are essential in understanding the movement and pattern of hydrologic processes within the watershed. The paper provided potential implications of land conversions and climate change scenarios on the hydrologic processes of Muleta watershed using soil and water assessment tool model. Model inputs...
متن کاملEvaluation of WEAP-MODFLOW Model as an Integrated Water Resources Management Model for Sustainable Development (A Case Study: Gharesoo at Doab-Merek, Kermanshah, Iran)
This paper evaluated an integrated water resources management approach through linked WEAP-MODFLOW model. Study area is Ravasnar-Sanjabi plain located in Kermanshah province in the west of Iran. A MODFLOW model was evaluated and then, accepted as a groundwater model for the region in present research. Schematic WEAP model was provided as representing general features of water resources system a...
متن کاملIntegrated Assessment of Ferizi Watershed Based on Water Accounting Framework Using SWAT Model
Integrated assessment of the watershed is critical in arid and semi-arid areas due to the severe water stress in these regions. Data and information are an essential part of decision making and water governance to obtain integrated water resources management at the watershed scale. Water accounting is a helpful tool to organize information and present them as the standard indicators to achieve ...
متن کاملThe Impact of the Phenomenon of Drought on Groundwater Quantity using Fuzzy Model (Case Study: Plain Gotvand- Aghili)
Abstract The negative balance of water reserves and reduce the size of static storage aquifers including the effects of the drought phenomenon is repeated on the status of surface and groundwater resources in Iran including Khuzestan province has had an impact. In this study, using fuzzy and ArcGIS version also better understand the effects created in the statistical period on the aquifer Gotv...
متن کامل