Ultrasonic Monitoring of Recrystallization Textures in Aluminum
نویسنده
چکیده
The present paper is an attempt to use ultrasonic velocity measurements to characterize the texture of an aluminum-magnesium alloy ( Al 5xxx ) and to compare the results with orientation imaging microscopy ( OIM ) results. The results are characterized in terms of three orientation distribution coefficients ( ODC's ), W400 , W420 , and W440 , each of which describes a particular forming anisotropy, and each of which has significant impact on the final products.
منابع مشابه
Recrystallization textures and microstructures of Al-0.3%Cu alloy after deformation to high strains
An Al-0.3%Cu alloy was deformed to high strains by cold rolling. The as-deformed samples were annealed at different temperatures until complete recrystallization. The cold rolling textures were determined by X-ray diffraction while the recrystallization textures and microstructures were characterized by electron backscatter diffraction. It was found that the rolling texture was characterized by...
متن کاملDevelopment of Recrystallization Textures in Deep-Drawing Steels, Measured by X-Ray Diffraction and EBSD
The development of recrystallization textures in two low carbon steels used for deep drawing has been investigated through measurements of global textures (by X-Ray diffraction) and local orientations (by EBSD, Electron Back Scattering Diffraction). The global measurements allow a quantitative description of the recrystallization textures whereas the local measurements allow to identify some of...
متن کاملAttenuation and Dispersion of Ultrasonic Wa Yes in Rolled Aluminum
Measurements of ultrasonic velocity and attenuation can provide important tools in characterizing the microstructure of materials [1]. For example, velocity measurements can provide information on crystallographic texture while attenuation measurements provide information of grain size. For selected cases, a strong theoretical base is in place [2-4]. However, when both texture is present and th...
متن کاملDry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning
Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...
متن کاملEvolution of microstructure and texture during recovery and recrystallization in heavily rolled aluminum
The annealing behavior of nanostructured aluminum AA1050 prepared by cold rolling to an ultrahigh strain (vM = 6.4) has been investigated using both transmission electron microscopy and electron backscatter diffraction techniques, paying particular attention to changes in microstructure and texture during recovery and their influence on subsequent recrystallization. It is found that coarsening...
متن کامل