Water-Immersible Micromachined Pb(Zr,Ti)O3 Thin Film Actuators

نویسندگان

  • YONGBAE JEON
  • CHEE WEI WONG
  • SANG-GOOK KIM
چکیده

We demonstrate a water-immersible thin film lead zirconate titanate, Pb(Zr,Ti)O3, [PZT] actuator, without special passivation layer, towards in-vivo or in-vitro scanning probe microscope (SPM) measurements of living cells in water or biological fluids. In order to be water-immersible, the electrodes need to be electrically insulated and the piezoelectric layer needs to be protected against direct water contact. This paper describes our design solution with a simple fabrication process for a water-immersible piezoelectric device, which separates the bottom electrode from the top electrode by having a narrow ditch covered with PZT film. The PZT film is then encapsulated with the top metal electrode without insulation layer. In this structure, the PZT is sandwiched between the top and bottom metal electrodes to prevent water permeation. The device is fabricated using lift-off processing for the bottom and top electrodes, sol-gel spinning for the PZT thin film and wet etching for the PZT patterning. The piezoelectric constant, d31, is about −100 pC/N. The dielectric polarization and fatigue properties of the devices were measured in air and water. The spontaneous polarization, remnant polarization, coercive field and dielectric constant are 54 μC/cm2, 15 μC/cm2, 60 kV/cm and 1200, respectively. The polarization property of the device was unchanged in either air or water up to 1 × 109 continuous cycles.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Processing and Characterization of Piezoelectric Materials into MicroElectroMechanical Systems

The Pb(Zr, Ti)O3 (PZT) based micro electro mechanical systems are presented. Piezoelectric effect, basic piezoelectric equations are explained. Lost silicon mold process for PZT microstructures, PZT thin film deposition, and PZT based piezoelectric micromachined switch device are discussed.

متن کامل

Thin-Film Process Technology for Ferroelectric Application

Recently thin-film ferroelectrics such as Pb(Zr, Ti)O3 (PZT) and (Ba, Sr)TiO3 (BST) have been utilized to form advanced semiconductor and electronic devices including Ferroelectric Ran‐ dom Access memory(FeRAM), actuators composing gyro meters, portable camera modules, and tunable devices for smart phone applications and so on. Processing technology of ferro‐ electric materials is one of the mo...

متن کامل

Sol–gel derived Pb(Zr,Ti)O3 thin films: Residual stress and electrical properties

Pb(Zr,Ti)O3 compositions are under investigation for applications that include integrated capacitors, piezoelectric sensors, and actuators. Sol–gel synthesis and spin coating are popular routes to the formation of high quality, dense, crack free, insulating films. However, the electrical properties of the films are often different than those measured for bulk specimens of the same composition. ...

متن کامل

High coupling piezoelectric thin films of Pb„Zr,Ti...O3-based ternary perovskite compounds for GHz-range film bulk acoustic resonators

We have deposited nearly stress-free single-crystal thin films of 001 Pb Mn,Nb O3–Pb Zr,Ti O3 PMnN-PZT on 001 MgO substrates by rf-magnetron sputtering using a quenching process after the film growth. It is found that single c-domain/single-crystal thin films of PMnN-PZT containing 5%–10% PMnN show a strong hard ferroelectric response with 2Ec 400 kV /cm and Ps 70 C /cm2. GHz-range film bulk ac...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004