Hydrogenation Properties of TiFe Doped with Zirconium
نویسندگان
چکیده
The goal of this study was to optimize the activation behaviour of hydrogen storage alloy TiFe. We found that the addition of a small amount of Zr in TiFe alloy greatly reduces the hydrogenation activation time. Two different procedural synthesis methods were applied: co-melt, where the TiFe was melted and afterward re-melted with the addition of Zr, and single-melt, where Ti, Fe and Zr were melted together in one single operation. The co-melted sample absorbed hydrogen at its maximum capacity in less than three hours without any pre-treatment. The single-melted alloy absorbed its maximum capacity in less than seven hours, also without pre-treatment. The reason for discrepancies between co-melt and single-melt alloys was found to be the different microstructure. The effect of air exposure was also investigated. We found that the air-exposed samples had the same maximum capacity as the argon protected samples but with a slightly longer incubation time, which is probably due to the presence of a dense surface oxide layer. Scanning electron microscopy revealed the presence of a rich Zr intergranular phase in the TiFe matrix, which is responsible for the enhanced hydrogenation properties of these Zr-doped TiFe alloys.
منابع مشابه
Nickel Hydrogenation Composite Catalysts Modified by Zirconium in Competitive Benzene Hydrogenation: Effect of Modifiers
A co-impregnation method was applied to the Ni/Zr-HMS/HZSM-5 catalyst (with various amounts of zirconium) during the hydrogenation of benzene. The physicochemical properties of the prepared nickel catalyst were characterized using X - ray diffraction, X - ray fluorescence, Fourier transform infrared spectroscopy, ultraviolet-visible diffuse reflectance spectroscopy, temperature-programmed desor...
متن کاملComparison of doped combination zirconium-tungsten, zirconium- molybdenum and molybdenum-tungsten on single-wall vanadium oxide nanotube in hydrogen gas adsorption
In this study, doped vanadium oxide nanotubes were evaluated using different software to study the absorption of hydrogen gas. Vanadium oxide nanotubes are one of the options for absorption and storage hydrogen gas. In this research study for the first time, the Monte Carlo simulation was used to investigate the hydrogen gas absorption behavior in molybdenum-tungsten, molybdenum-zirconium and z...
متن کاملStudy of Saturation and Supersaturation of Zr-Doped Vanadium Oxide Nanotubes
Vanadium oxide nanotubes belong to inorganic nanotubes. One inorganic nanotubes (WS2) synthesized in 1992.Vanadium oxide nanotubes discovared by spahr in 1998.Vanadium oxide nanotubes are used in chemical, bio, electronics and catalysts industry. Many applications of these nanotubes have not yet been discovered. Especially when these nanotubes are doped with different elements. The structure of...
متن کاملPhotocatalytic Degradation of Acid Yellow 36 Using Titanium Dioxide Nanocomposites Doped by Zirconium
Introduction: In this research, TiO2-Zr nano-photocatalyst was firstly developed with the aim of improving the photocatalytic activity of titanium dioxide via sol-gel method. The recovery of catalysts in acidic, alkaline and thermal conditions was also studied. Method: This research was done on a laboratory scale. The structures and properties were recognized with (BET), (FT-IR), (FE-SEM), and...
متن کامل