A 2.4-6.0 GHz High Gain LNA for Broadband Applications
نویسنده
چکیده
In this work 0.18 μm CMOS is used to achieve low-characteristics and best performance of in the band of 2.4 GHz to 6.0 GHz. Here simulation tool is used for simulation of lumped components with an inductor less concept. Designed broadband LNA supports multi standard wireless applications with High gain and low noise figure. Due to the accurate calculation and the proper impedance matching, the results are the forward gain (S21) is 18dB and Noise figure is less than 2.4dB. Input impedance (S11) and output impedance (S22) also represent good performance. Third order intercept point is -5.25dBm is obtained with the linearity and the performance is good, so that the LNA circuit gives good availability for wireless applications and broadband applications.
منابع مشابه
A Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers
A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...
متن کاملA High-gain Cmos Lna for 2.4/5.2-ghz Wlan Applications
This paper describes a high-gain CMOS low-noise amplifier (LNA) for 2.4/5.2-GHz WLAN applications. The cascode LNA uses an inductor at the common-gate transistor to increase its transconductance equivalently, and therefore it enhances the gain effectively with no additional power consumption. The LNA is matched concurrently at the two frequency bands, and the input/output matching networks are ...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملA 0.18-μm 2.4~6GHz CMOS Broa For WLAN and UW
A 2.4-6 GHz broadband CMOS differential LNA for WLAN and UWB receiver is presented. The LNA is fabricated with the 0.18 μm 1P6M standard CMOS process. Measurement of the chip is performed on a FR-4 PCB test fixture. In the UWB low-band (3 to 5.15GHz), the broadband LNA exhibit a gain of 17.5-18.2 dB, noise figure of 3.4-5dB, input/output return loss better than 10 dB, and input P1dB of –17 dBm,...
متن کاملDesign of a New Low-Power 2.4 GHz CMOS LNA
A 2.4-GHz single-stage CMOS low noise amplifier (LNA) structure with ultra low power consumption is proposed. A current reuse technique is used to decrease power dissipation with increasing amplifier transconductance for the LNA. Thus, the same amplifier transconductance for the LNA will be achieved at decreased power dissipation. Also, due to the use of an inverter-type amplifier which has a s...
متن کامل