Measurement of Emissions from Air Pollution Sources. 2. C1 through C30 Organic Compounds from Medium Duty Diesel Trucks

Gasand particle-phase tailpipe emissions from latemodel medium duty diesel trucks are quantified using a twostage dilution source sampling system. The diesel trucks are driven through the hot-start Federal Test Procedure (FTP) urban driving cycle on a transient chassis dynamometer. Emission rates of 52 gas-phase volatile hydrocarbons, 67 semivolatile and 28 particle-phase organic compounds, and 26 carbonyls are quantified along with fine particle mass and chemical composition. When all C1-C13 carbonyls are combined, they account for 60% of the gas-phase organic compound mass emissions. Fine particulate matter emission rates and chemical composition are quantified simultaneously by two methods: a denuder/filter/PUF sampler and a traditional filter sampler. Both sampling techniques yield the same elemental carbon emission rate of 56 mg km-1 driven, but the particulate organic carbon emission rate determined by the denuder-based sampling technique is found to be 35% lower than the organic carbon mass collected by the traditional filter-based sampling technique due to a positive vapor-phase sorption artifact that affects the traditional filter sampling technique. The distribution of organic compounds in the diesel fuel used in this study is compared to the distribution of these compounds in the vehicle exhaust. Significant enrichment in the ratio of unsubstituted polycyclic aromatic hydrocarbons (PAH) to their methyland dimethyl-substituted homologues is observed in the tailpipe emissions relative to the fuel. Isoprenoids and tricyclic terpanes are quantified in the semivolatile organics emitted from diesel vehicles. When used in conjunction with data on the hopanes, steranes, and elemental carbon emitted, the isoprenoids and the tricyclic terpanes may help trace the presence of diesel exhaust in atmospheric samples.